A: Hi Waylon430, The overall width of the Sportstar I trailer (fender to fender) is about 63 inches. Please let us know if you have any other questions. We are more than happy to help. 801-375-3088. Thank you, Northstar Trailer
A: Hi Ron, The width from fender to fender on the Sportstar I ATV Trailer is 63". Please let us know if there is anyting else we can help you with. Sincerely, Northstar Trailer
A: Hi Gearhart, Yes, the sides can be removed by removing the bolts attaching the side rails to the frame of the trailer. Please let us know if you have any questions. Thank you, Northstar Trailer
A: Yes, by removing a lot of nuts and lock washers, or never installing the side rails. However you will not be able to lock the tail gate in a vertical position with out the two rear upright pieces installed.
A: Hi Sas, As long as the bearings are properly greased, all bolts are tightened and checked often, and tires are filled properly and checked, it should be able to make a 2000 mile trip. Please let us know if there is anything else we can help you with. 855-375-3088. We are more than happy to help. Sincerely, Northstar Trailer
A: Center to center of each spring is 49" by my measurement.
A: Yes, this will fit a dirt bike.
A: I have a craftsman 42”deck riding mower that fits on my trailer without any problems. I just have the lift the plastic grass vent when I drive it onto the trailer.
A: No, the trailer kit doesn't have vin numbers.
A: yes. The VIN is good in California.
A: The Sportstar I is our smallest and least expensive trailer. However, the rear gate may be too steep for a wheelchair.
A: Use a hitch hauler, don't buy a trailer