Hello whym, thank you for your question. No, this remote does not have to be programmed. If you have any other questions, please give us a call between the hours of 7 AM – 8 PM Central Standard Time, Monday thru Friday at 1-800-654-8483, press option 4
The controller must be installed before the first light in the line of lights to control all linked lights.
Hello James, thank you for your question. The motion sensor activates the lights but they turn off after they don't since motion after about 30 seconds, so I don't think you need a timer. If you have any more questions, please give us a call between the hours of 7 AM – 8 PM Central Standard Time, Monday thru Friday at 1-800-654-8483, press option 4
Hello Vince, thank you for your question. The remote uses a CR2025 type battery.
Hello Doug, thank you for your question. If the lights are linked together, no matter how many lights you have they will work on one switch. If you have any other questions, please give us a call between the hours of 7 AM – 8 PM Central Standard Time, Monday thru Friday at 1-800-654-8483, press option 4
Hello Gary, thank you for your question. We may have some cords in our consumer care department and they go all the way up to 120in. Please give us a call between the hours of 7 AM – 8 PM Central Standard Time, Monday thru Friday at 1-800-654-8483, press option 4
Hello Jimm, thank you for your question. No, this cannot be converted to hardwire. If you have any other questions, please give us a call between the hours of 7 AM – 8 PM Central Standard Time, Monday thru Friday at 1-800-654-8483, press option 4
Hello Eric, thank you for your question. Yes, but the remote is not sold separately. You would have to buy the entire ProLink In-Line Switch Kit. If you have any other questions, please give us a call between the hours of 7 AM – 8 PM Central Standard Time, Monday thru Friday at 1-800-654-8483, press option 4
There are two outputs, one controlled by the dimmer and one always-on. The dimmer affects the voltage to that output, so everything running from that output is affected by the dimmer and can also be turned off individually with the power switch on each light unit.