A: Mostly made in Germany . Series 100 usa .
A: Did not see any. But is easy use,
A: Not that it works on triangles but it does
A: No instructions and it doesn't seem to work like the other Bessey strap clamps. In the others the strap is connected and it is obvious that turning the handle will tighten the strap. This one has a loose piece of the strap on the other side from the roll, and turning the handle doesn't tighten it. Plus, only 3 corners can be detached from the strap, leaving one built in.
A: I don't know how to edit my previous answer. Have since learned how it works, and maybe for a more tool savvy person it would be clear without instructions. Start with the handle turned until the top of it touches the Bessey logo piece. This is as far as it will go. The red levers on each side lock and unlock the strap. So, with the lever on the roll side open to a vertical position, you pull out the length of strap needed from the roll, put it around the object, then close the lever by pulling it down to a horizontal position. Then, you open the lever on the side with the short piece of strap, by pushing the red lever to a vertical position. Pull the strap tighter around the object, pulling on the end of the strap. Then put the lever in the horizontal position to lock it. Finish tightening by turned the handle. Remove from object when finished by opening the lever again to the vertical position, then loosen and remove strap from object. It actually takes longer to explain than to do it and is quite simple when you know how.
|Name||90-Degree 250 lb. Angle Clamp w/(2) Table Clamps||Strap Clamp with 90-Degree Corner Pieces 12 ft. Capacity||Quick-Release 90 Degree Angle and Corner Clamp||16 ft. Ratcheting Variable Angle Strap Clamp|
|Jaw Width||4||1.25 in||3||1|
|Clamping Strength (lb.)||250||0.0||250||0|
|Hand Tool Type||Clamp||Clamp||Clamp||Clamp|
|Throat Depth||4||0.0 in||2.5||0|
|View Product||View Product||View Product||View Product|