Safety+PLUS2 (1/2 in. O.D.) Gas Dryer and Range Installation Kit w/ Thermal Excess Flow Valve (60,500 BTU)

Hello Gini - Thank you for your question. Due to limitations put in place by relevant codes and standards, 72" is the longest gas connector length that is allowed to be made. If you have any additional questions or concerns regarding our products, please reach out to our Customer Support Team toll free at 877-272-7755.

Hi Geoffrey - Thank you for your question. Our BrassCraft gas connectors can be used with natural, manufactured, mixed and liquefied petroleum (LP or propane) gases, and LP gas-air mixtures. As with any installation, you should ensure that the application meets all of our application specifications and you have you the proper size connector for the flow capacity of the appliance. Gas connectors should be sized based upon the appliance gas consumption rate. You should select a connector with a capacity equal to or greater than the appliance input rate. Please give us a call if you have any other questions or need assistance in choosing a gas connector or kit. Our Customer Support Team can be reached at 877-272-7755.

You're smart not to try to bend a hard elbow out of the corrugated BrassCraft gas line,which is designed for soft bends only. I don't know about their branded fittings, but if you need to come off the dryer gas connection at a short 90 degrees, why not just get a black pipe elbow? The range connection is likely male or female 1/2 NPT pipe thread. Unions are readily available at Home Depot in that size at reasonable cost. Just be sure to use pipe thread sealant or yellow gas teflon tape and check for leaks. If you instead have a flared compression fitting connection out of the range, Home Depot stocks those connectors as well (in copper). The connection options in the Brasscraft kit should marry to anything you have.

We appreciate your question and would like to gather more information from you to best assist you. Please contact one of our Customer Support Team Members at 877-272-7755 and reference this review.

Hi Rasdus - Thank you for your question. We would require more information to determine if our Connector is designed for that use. This kit is designed for range and dryer appliances. Please contact our Customer Support Team at 877-277-7755 and reference this review.

We appreciate your question and would like to gather more information from you to best assist you. Please contact one of our Customer Support Team Members at 877-272-7755 and reference this review.

Hi Ti, We appreciate your question and would like to gather more information from you to best assist you. Please contact one of our Customer Support Team Members at 877-272-7755 and reference this review. Thank You, Lafon

Yes, this is a universal kit for all current U.S. standard dryers and ranges.

Hello Gilly-Thank you for your question, When the length is extended it does reduce BTUs. We would be happy to speak to you more about your issue to determine if we can assist further. Please give our Customer Support Team a call at 877-272-7755 and reference this review.

Hello John-The Safety+Plus2 valve (excess flow valve) would not work on the shut off valve, if yours is a flared ball valve. The Safety+Plus2 is a has male threads and needs to be connected to a female ball valve. This Safety+Plus2 valve has to be connected directly to the gas shut off, with the directional arrows pointing to out put of the gas (toward the appliance), flared end would connect to a fitting or directly to the gas connector. The fittings that come with the kit include one of the AU2-8S 1/2" MIP (tapped 3/8" FIP) steel fitting, 1 of the AU1-8S 1/2" FIP steel fitting, 1 of the AU2-8-6S 3/8" MIP steel fitting, 1 of the 3mil tube of pipe thread sealant, and 1 of the 3mil tube of leak detection solution. Please contact our Customer Support Team at 877-272-7755 if you need further assistance.