A: Mine were individual. I ordered 6 and cost like $30 so not cheap but they did the job and I didn't need many.
A: Hello, unfortunately we do not offer that accessory. You may want to check your local metal shop. Thank you
A: Hello, thank you for your question. There have been no issues with the use of these aluminum individual corners and the proprietary blend of our fiber-cement siding. Thanks for your question.
A: Might only happen when concrete is wet or curing, which is not the case here. But it shouldn't matter anyway if the fiber cement shingles are primered and painted before adding the corner pieces. Mine are unscathed and have been there since 1940. I replaced only a few because they were bent.
A: I think they are 2 inches wide on each side of the corner. I needed 1 inch to match the pieces on my house so I am having mine trimmed at a local shop.
A: Hello, the 12" aluminum corner should be approximately 3.25" in width at both the top and the bottom of the corner piece. There is really no taper in this design from top to bottom. Thank you for your question.
|Name||WeatherSide 12 in. Individual Aluminum Corner (Piece)||WeatherSide 15-1/2 in. Emphasis Individual Aluminum Corner (Piece)||WeatherSide 14 in. Individual Aluminum Corner (Piece)||All Weather System Starter Strip 3.28 feet|
|Product Width (in.)||3 in||14.625 in||3 in||.59 in|
|Trim type||Outside Corner||Basic trim||Outside Corner||Basic trim|
|Product Length (in.)||12 in||25.156 in||14 in||3.28 ft|
|Product Thickness (in.)||3 in||0.281 in||3 in||1|
|View Product||View Product||View Product||View Product|