Horizontal Non-Programmable Thermostat with Digital Backlit Display

Had this happen to me. My old white wire was attached to the "W" terminal so I wired this one up the same. Finally had to call a heat pump guy and even he had to call a friend because he thought it appeared to be wired up correctly also. Finally figured out the white wire had to hooked up to the W2 terminal. This fixed the problem. Hope this helps.

Hi joannelferry, this thermostat can be set to Manual instead of automatic. Please feel free to contact our tech support team for further information at 1-800-468-1502. Monday - Friday 9 am to 8 pm, Saturday - Sunday 9 am to 5 pm CST. We will be happy to assist you.

Danielle, I was having the same problem with my thermostat when I installed it. What i found is that i believe there is a 2 degree difference between the temperature settings on the thermostat. In my case when I wanted to set my thermostat to 72 degrees, I found when then inside temperature reached 72 degrees the ac continued to run. But if i set my thermostat to 74 degrees when the inside temperature reached 74 degrees the ac would shut off as it was supposed to. So try setting your thermostat up by 2 degrees and see if that solves your problem

The large number on display screen is the actual room temperature the small number above that is your temperature setting example if your room temperature is 75° and you want your room to be 80° you need to press the plus button until that small number goes up to 80 degrees then the heat will come on approximately after a minute or before heat will come on but if you're setting is at 75 and your room temperature is at 75 degrees heat will not come on until room temperature go below 75 degrees then it will come on

Yes

This from the current information on the Honeywell Home web site (https://www.honeywellhome.com/us/en/products/air/thermostats/non-programmable-thermostats/): Product Height 3.86 in Product Length 5.36 in Product Width 1.08 in (FYI, Honeywell spun off home thermostats and some other home electronics to form an new company, Resideo. Honeywell Home is made by Resideo under license. Documentation and customer support come from Resideo.)

In system setup option number 200 for heating system type select option number 5 for none cool only. If this doesn't work recheck your wiring

Press the middle button between the Plus and minus button for menu press once for display light to come on press it again to go into mode selection press plus button to change from cool to heat or Auto mode then press the middle button for done. Then used plus or minus button for temperature setting

Make sure your fan is in fan Auto not fan on mode. Press the middle button between the plus button and minus button this is your menu button press once the display light will come on press it again then it will go to mode selection press the minus button to alternate between fan Auto and fan on select fan Auto then press the middle button for done fan Auto should be on display screen. Press your plus or minus button for room temperature settings

Press the menu (center) button, the the top (+) button which has the word 'mode' displayed to the left of it. Pressing the mode button repeatedly will let you cycle between 'Off', 'Heat, 'Cool' and 'Auto'. Press the center button when finished.