Wiremold Cordmate II Cord Cover Kit, White

Excellent price,look great and super easy to do it for a woman

Had about 29' of speaker wires to cover. Bought 2 of the Cordmate II cover kits plus a 5' section. Measured out the distance then laid out the pieces as I had seen on install videos. Installation was smooth and easy. Attached these to a smooth baseboard so I expect the pieces will adhere over the long term. Very pleased with the result. I recommend this product.

It worked well.Easy to use and made the TV look better without messy wires

Very well made and makes for a neat installation.

Meet our need, easy to install

Easy cut with a knife a was able to use just one 4ft stick for 3 diffrent things and still have 2 more to use for another project.

Rros: easy to use and looks great. Cons: pure sticking to a brick surface. I needed to drill holes and put a couple of screws to keep the wiremold in place.

This is an update to my April 2017 review where I gave this product 5 stars. I will admit that I do have textured walls in an (Orange Peel) which is not the recommended wall surface intended to be stuck to. Nonetheless, this product stuck to my walls perfectly for about a year to a year and a half, but then in a few locations, the adhesive gave out and I could see cordmate dangling from the walls. At first I just tried to re-stick the cordmate back into place. But then I realized that I would need to permanently mechanically fasten them to the walls. The perfect solution I came up with is to use another Home Depot product, "EZ Anchor Drywall & Stud Anchor". These come in either a 20 count or 50 count box. You simply install maybe three anchors per 4 foot piece of cordmate, one on each end and one in the middle. Stick up your cordmate as usual but then with the cordmate opened up, pre-drill your holes with a 3/16" drill bit, just through the cordmate into the drywall, it is not necessary to drill too deep, you basically just want to get through the plastic. Then just screw the self-drilling zinc anchor with either a screwdriver or cordless drill and drive it all the way in flush with the back of the cordmate. You don't use the attached screws that come with the anchors, just the zinc anchors will be sufficient to hold the cordmates permanently to the walls and they will never come down at any point. See the attached product image.

Perfect

Great product. Easy to use. If you ever needed to switch the cords you had originally hid, it is easy to replace cords while leaving the cord covers in place. I was able to easily saw the pieces into appropriate sizes that made the finished product look great. It hides cords and looks professional.