100 ft. 75 lb. 14-Gauge Galvanized Steel Wire

Yes, I was able to drill a small hole in a block of wood and use my drill to straighten the wire (look on youtube). Some parts aren't super straight but it gets it close enough. Good luck.

Yes I would think so- it really depends on the weight of the “limbs” or vines...

BobG gave an answer of .0641" which is the diameter for 14 gauge plain steel wire. This wire is galvanized coated wire which makes the wire have a larger diameter than .0641". The actual diameter for this 14 Gauge wire is not given...

Yes, this product should work for your application.

The whole point of galvanization (applying a protective coat of zinc) is to prevent rusting when the wire is used outside. Actually *all* of my uses for this wire have been for outside uses in the midst of wind and rain and even monsoons and it holds up very well versus exposed copper or iron rebar which do in fact rust.

Hi Thomas and thank you for your inquiry. We apologize we do not carry clamps that could be used on these items.

11 gauge was also strong enough and easier to work with. I used it in 2017. I had both 12 and 14, but this year I tried 12 and it was a little tougher to work with. Thicker. https://www.homedepot.com/p/The-Hillman-Group-100-ft-12-Gauge-Galvanized-Wire-122339/203721762

No, painting this wire is not recommended.

Im sure the wire would hold up, may be a little hard to stick hot glue to it unless you lay it on heavy.

Wouldnt be my first choice, unless you greased it first. Being that it is galvanized it has a tenancy to rust easy.