3/4 in. x 100 ft. Coil Blue PEX-B Pipe

A:  Hi, The SharkBite 1/2 in. x 100 ft. Coil Red PEX Pipe can not be heated. If you have any more questions please call tech support at 877-700-4242. (Kind regards,)

A:  yes but be careful. I assume you want to bent it slightly. Use a hair dryer or heat gun on low power. DO NOT use a propane torch

A:  That, I guess, would depend on how much heat is involved. The red is intended for use as hot water line and will certainly withstand the 212 degree temperature of boiling water. Past that?

A:  Hi, The SharkBite 3/4 in. x 100 ft. Coil Blue PEX Pipe can be used with these products for sealing. Latex caulk, Latex foam, Silicone sealant, and Polyurethane expanding foam. If you have any more questions you can call tech support at 877-700-4242. (Kind regards,)

A:  Yes

A:  Yes.

A:  This is an easy and good product without any torch and solder. I used it outside with insulation and still holding for hot water and its been 3yrs

A:  Hello, We do offer 1/2" PEX in a 50' roll. I've attached a link to our 1/2" PEX. If you have any more questions you can contact tech support at 877-700-4242. (https://www.sharkbite.com/products/pex-pipe) (Kind regards,)

A:  Hello, The SharkBite 1/2 in. x 100 ft. Coil Blue PEX Pipe can be used for your hot water line. If you have any more questions you can contact tech support at 877-700-4242. Kind regards,

A:  Nothing will happen to you if you use blue pipe for hot water, except everyone after you will assume that is a cold water pipe, and it will take them a while to figure out that you used blue pipe for hot water. One solution is to attach a little bit of red tape to the blue pipe, and then people after you will know that is for hot water.

A:  It will turn the hot water into cold water.

A:  As far as strength same psi just coded blue for cold water I have never done it don't cost much for a hole roll.

A:  It works except you have to identify it as running hot water