Questions and Answers for Delta 1/2 HP 12 in. Disc Sander

A:  You are correct! The picture you have is a 31-120 and not a 31-140. We don't sell the 31-120 only the 31-140. If purchased, you would get the latest 31-140. You can see the 31-140 via www.deltamachinery.com under products. I have requested them to change picture.

A:  The 12" Disc Sander MODEL NUMBER: 31-140 is a tabletop sander and doesn't have or come with a stand. However, you might check out the stand model number 22-592. This might work.

A:  The 12" Disc Sander MODEL NUMBER: 31-140 is a tabletop sander and doesn't have or come with a stand. However, you might check out the stand model number 22-592. This might work.

A:  The 12" Disc Sander MODEL NUMBER: 31-140 is a tabletop sander, no stand is required. But you can try stand 22-592.

A:  12" Disc Sander MODEL NUMBER: 31-140 parts, please contact Delta Power and Equipment at 800-223-7278 or you can email at customercare@dpec-na.com.

A:  31-140 adds to the 31-120: a dust collector system a disc braking lever. Need to carefully at image for the dust hose and for a lever atop the disc guard. The sample above is a 31-120.

A:  31-120 12" Disc Sander specs: Motor: 1/2 H.P., 120V, Single Phase, Disc Speed: 1725 RPM Disc Size: 12", Table Size: 17-1/4" x 6-1/4", Table Tilt: 45º up and down, Height: 15" Width:17-1/4", Depth:17-3/4", Weight: 72 lbs, which is the same specifications as the 31-140 12" Disc Sander. You can match by going to www.deltamachinery.com.

A:  The width of the table is 17 1/4” and the miter gauge groove is 3/8” deep x 3/4” wide.

A:  Features a 3/8" x 3/4" miter gauge slot machined into the table for projects that require sanding an angle or straight edge. This is supported by Delta Model 34-929 Table Saw Miter Gauge "Deluxe".

A:  yes

A:  Yes. Fits my old craftsman miter gauge and measures 3/4”