Q:Purchased the 8 lineal foot kit, instructions that came with it says to leave 1/4" gap in corners, web site says 1/8", which is correct?
by|May 26, 2024
1 Answer
Answer This Question
A: Thank you for your inquiry, Roger. Leave 1/4" gap on the corners, is the correctn dimension.
by|May 28, 2024
Q:Purchased a 8 linear foot kit, instructions that came with it say to space boards 1/16” or width of a nickel, web site says space 1/32”. Tounge is only 1/8” so 1/16 seems quite a bit. So which measurement is it ??
by|May 18, 2024
1 Answer
Answer This Question
A: Thank you for your inquiry, Roger. Leave 1/32" for contraction and expansion.
by|May 21, 2024
Q:How thick are the panel boards?
by|Mar 20, 2024
1 Answer
Answer This Question
A: Thank you for your inquiry, Brian. These are 5/16" in thickness.
by|Mar 26, 2024
Q:can this be installed over firing strips or does it have to be a solid surface
by|Jun 21, 2023
1 Answer
Answer This Question
A: Thank you for your inquiry, Frank. This Oak Tongue and Groove wainscot paneling can be installed on both, firing strips or on a solid surface.
by|Aug 15, 2023
Q:What type of trim do you use on the side of the wall to finish it off along the wainscoting and your top chair rail and your bottom chair rail what finishes the side
by|Jan 11, 2023
1 Answer
Answer This Question
A: Thank you for your inquiry Dars. Use the top chair rail and mitre it 90 degrees to follow along the side of the wainscot.
by|Jan 11, 2023
Q:What is the height in inches of the paneling in inches?
by|Jul 13, 2022
1 Answer
Answer This Question
A: Thank you for your inquiry, Bradlee. The dimensions of each T&G panel is 32" high by 3.14" wide (or 2.98" not including tongue).
by|May 11, 2024
1 found this answer helpful
Q:Can they be stacked on top of one another to cover a higher area 2 X 34" & 1/2" X 8'?
by|Jun 18, 2022
1 Answer
Answer This Question
A: Hello Bill, thank you for your inquiry. If you would like to cover a taller space you can install the wainscot panels one above the other, but keep in mind you will have a seam where the bottom level and top level meet. We hope this information is helpful in the planning of your current wainscot project.
by|Jul 5, 2022
Q:How far apart are is the beaded groove pattern spaced? 1 1/2 inch center-to-center? 2 inches? Thank you
by|Apr 13, 2022
2 Answers
Answer This Question
A: Hello Christina, thank you for your inquiry. The beaded groove pattern is spaced out 1-1/4 inch centre-to-centre. We hope this information is helpful in the planning of your current project.