Questions and Answers for King Electric 240-Volt 2250-Watt Pic-A-Watt Electric Wall Heater in White

A:  Yes. If you install it as deep in the bay as it will go, the "stud line" measurement at the front of the wall box will line up perfectly with the face of the adjacent stud.

A:  Yes, this can be installed in an internal wall with 2x4 studs. The depth of the wall can is 4 7/16". The installation instructions can be found here: https://king-electric.com/wp-content/uploads/kel_product_files/PAW-Installation-Instructions.pdf

A:  Just finished putting two on the same circuit in my shop. They're working great and not causing any problems. However, that is a 30A circuit with nothing else on it besides the two heaters, so there's a fair amount of extra ampacity. Per the spec sheet, the 240VAC version draws a maximum of 9.4 amps if it's wired for the full output of 2,250-watts. That's 18.8 amps for two of them, which leaves 11.2 amps. That's plenty of extra. However, you shouldn't wire this into a circuit that has other heavy, unexpected loads. If someone starts up a dryer or fills a big compressor on the same circuit, you may well trip the breaker... especially if it's a 20A circuit.

A:  A dedicated breaker is recommended however you can put this on a breaker with other devices. Just make sure the breaker is big enough to handle the amperage of all the devices. If you are not sure about your breaker we recommend checking with your electrician. If there's anything else we can help you with please contact tech support at tech@king-electric.com or (206) 762-0400 opt. 2. We'll be happy to assist you.

A:  This cannot be mounted in a ceiling. Our ceiling heater model# is WHFC1215-W and is also available on HomeDepot.com

A:  This model cannot be mounted in a ceiling. Look for model# WHFC1215-W, that is our ceiling heater.

A:  Sorry, unfortunately our heaters will not work for use in hot yoga studios.

A:  75 CFM

A:  King's web site says the squirrel cage motor moves 75 CFM.

A:  Our heaters do not have an efficiency rating as electric heat is 100% efficient. At 2250W this will be good for approximately 200-225 Sq.Ft. If you have any additional questions please contact tech support at tech@king-electric.com or (206) 762-0400 opt. 2. We'll be happy to assist you.

A:  Yes, you should be able to wire it into your RV electrical panel. Please note, the depth of this unit is 4-7/16" so you will probably want to surface mount this unless your walls are thicker. We also offer this in a stainless steel model, PAW1215-SS, available on HomeDepot.com.