A: This on/off switch has only be tested and made for an air compressor.
A: The right size
A: This On/Off Switch (Model# E103001) fits into an opening of 30.4mm x 22.5mm and is used in a shroud that is 2.0mm thick.
A: The line is supposed to be on but my switch was backwards
A: To turn this switch to "ON", you will need to flip it to the ( I ) position.
A: It has tabs in the inside that hold it in place. Just simple use a flathead screwdriver to remove the switch. You may be able to press the tabs in from the back of the board while you push the button out.
A: Please contact Product Services at 800-628-8815 for further assistance on removing the on and off switch as well as help with a replacement part.
A: This on/off switch has only been tested for the listed air compressor. We cannot recommend the use on a power washer.
A: If the switch is the same as the one on the compressor, then I would say yes. For the price you can try it.
A: Please contact Husky Customer Service at 1-888-HD-HUSKY (4348759) for assistance with your replacement part needs.
A: Please contact Husky Customer Service at 1-888-43-HUSKY (48759) for further assistance with your replacement part needs.
A: I don't know about your air compressor, but if you research like I did it may.
A: Again if the switch is the same as the one on the compressor, for the price I would try it.