Hi RinSF, thank you for your message. We want to make sure we address your question about the MP36. Please contact the Simpson Strong-Tie Customer Service team at 800-999-5099. We look forward to hearing from you.
Hi Paul, thank you for your question. The Mending Plate is designed for non-structural applications only; not for truss applications. The prongs (teeth) are about 3/8" long to help secure the plate to the wood. Place a wood block over the mending plate and hammer the wood block to embed the prongs. If you have more questions, please reach out to our Customer Service team at (800)999-5099. We look forward to hearing from you! - Stacy
Hi Eric, this is McKenzie with Simpson Strong-Tie. The Mending Plates are designed for wood-to-wood connections but they are for non-structural applications and are not for truss applications. If you are looking for a structural connection it would be best to reach out to the Engineer of Record for the job to see what he/she specifies. If you need more information or have additional questions, please contact the Simpson Strong-Tie Customer Service team at 800-999-5099. We look forward to hearing from you.
Hello DIYDave, this is Stacy with Simpson Strong-Tie. The MP mending plate comes in a galvanized coating which is a low level of corrosion protection. If these will be used in an interior dry environment then yes it could possibly work depending on what type of pressure treated lumber you have. If it will be used for an exterior environment then i would not recommend it. If you wish to discuss this further please call us at (800) 999-5099. We look forward to speaking with you.
Hi Beth, this is Ricardo from Simpson Strong-Tie. We value your time and would like to look into your concerns with the MP mending plates. Our Customer Service team is available to talk with you directly and discuss this issue with to find a solution. Please call us at 800-999-5099. We look forward to hearing from you.
Hi jack, thank you for your message. We want to make sure we address your question regarding the MP Mending Plate. The MP Plate could be used for trusses, but that will need to be evaluated by the designer for your project as we do not provide load ratings for the MP Plates. If you need more information or have additional questions, please contact the Simpson Strong-Tie Customer Service team at 800-999-5099. We look forward to hearing from you -Stacy
I think it’d be shaky.
Wont hold. Use Simpson Strong-Tie E-Z Base Black Powder-Coated Post Base for 4x4 Nominal Lumber
Hi handyhelper, thank you for your message. We want to make sure we address your question regarding the MP Mending Plates. The MP Mending plates are meant for joists in timber framing where you want to make a positive connection between materials, they have not been load tested so I can not give you a specific capacity of the part. Please also keep in mind that the MP Mending Plates are G90 Galvanized which is a low level of corrosion protection and not meant for exterior use. If you need more information or have additional questions, please contact the Simpson Strong-Tie Customer Service team at 800-999-5099. We look forward to hearing from you. -Stacy
For a temporary hold I would recommend have a new cedar post installed
While it’s possible to use these to hold 2 4x4’s together, I wouldn’t recommend based on limited axial support. To support such a load, would recommend bracing with four 2x4’s on each side to support front to back and side to side loads. This method is use to brace power/telephone poles.
Hi CdrQ, thank you for your message. We want to make sure we address your question regarding the MP36. That product is a versatile and easy-to-use mending plate for wood to wood connections, that does not require using nails or notching of the wood for installation. It is intended for non-structural applications only. If you need more information or have additional questions, please contact the Simpson Strong-Tie Customer Service team at 800-999-5099. We look forward to hearing from you. Thank you-Colin.
