Customer Reviews for ABB 60 Amp 8-Space 4 Circuit Spa Panel Main Lug Load Center (TL412R260GF)

Very good quality I’m happy with the job

It fit my needs perfectly. The knockouts were kind of hard to get out but all in all it was nice having everything in one box.

Worked as expected!

Can't really say much. It is a spa GFCI disconnect. It does what it's supposed to.

Worked perfectly!

Worked out great. Hot Tub up and running. :)

Works great and easy to install for an electrician. You may have to read the installation instructions if you haven’t installed it before so you know where to attach the wiring.

Panel is fine. The GE breaker is prone to premature failure.I replace them every 3-4 years.

I was replacing a very old panel that a connector had failed on.The 60 amp breaker in this new panel didn't work. Spent a couple hours diagnosing and found that it worked fine with the 60 amp breaker from the old panel and not with the new breaker. Did not want to remove everything again to return,

Just what I needed for a new hot tub installation. I was able to add a 110 breaker easily to power a low voltage exterior lighting set up (a 4 wire source was required for this, which I installed).

Easy install

Works as expected. Good quality

WENT FINE INSTALLED QUICKLY TOO PRICY THOUGH

These are poorly made spa panels. The only reason I bought this one, its seems to be the only one available.

Exactly what we needed to replace the 60 amp GFCI breaker. Could not find just the breaker.

Works great

Worked as described.

Simple to install

Has everything you need with in the box. The only item to make sure to get is a wip to connect to the tub.

Easy to assemble

I was crossing my fingers that the people that had issues with this Spa Panel had lemons. This was installed on Saturday morning. Hot tub worked just fine. Used it for a couple of nights. Here I am on Wednesday following the Saturday of hookup and the breaker tripped. I was hoping it just tripped but after checking all connections and seeing that the wires were still hot coming into the panel box, I knew I had a bad one. Like others, I will have to take this defective breaker back to the store. Hopefully they replace it with a different model so that this is a one time occurrence. Great price, but unfortunately at $100, you get what you pay for with this model.

Compact size. Works great. All as advertised.

Working well so far has been used for about a month now. No issues. Very happy with purchase

Rating provided by a verified purchaser

After all the time spent installing this panel, I was ready to flip the switch and enjoy my spa. However the circuit breaker was bad out of the box. And in reading reviews apparently this is a common occurrence...why continue to carry a product you know is defective...you should reimburse for wasted time!

GFI breaker did not fit snugly, Somewhat confusing determining phase connections and neutral connections

Great price and quick delivery on product. Excellent choice.

It installed easily and so far has performed well.

Watch out with this one. If you have bottom input and output and wire larger than #6 then you will have no problems. Note that most installations fall in this category. If you have top input or output or #8 wire, as many older spas have, then you are in trouble. The lugs on this unit take a minimum #6 wire. My existing #8 wire was too small. There is a hole for a top hub. I could not find this hub at Home Depot, Lowes or Electrical supply . The screw spacing on the hub hole is unusual. If you find a hub that fits then you have to use expensive reducing fittings to get down to 1" or 3/4" conduit.

I think everyone can relate to the work it takes to install one of these. Attach conduit, run the cable, cut it to length, connect from panel, test it out, then attach your Spa...and..and..where is the screw and harness to attach the neutral. No where to be found... Hmm.... I'd open the box to ensure all piece are intact. My box was completely sealed and gave me no reason to validate.