Customer Reviews for DIABLO 10in. x 50-Tooth Combination Saw Blade for Wood

Sharp teeth are a must for clean accurate cuts. I have found her the 40 years of woodworking that diablo blades are the best

Excellent general purpose blade. I was very surprised at the cut quality I got from this blade. I'm using it for a furniture build and don't even feel like I'd need a 60+ tooth blade even for high precision cabinet work. Keep the kerfs cleaned out with a toothbrush every once in a while and you'll get great cuts every time. Attached photos are cuts made from the blade after already making 150-200 other cuts. I'd purchase this blade again in a heartbeat.

Cuts very good

Excellent blade for all cuts, cross cut, rip cut, dados.

Cut a stack of hardwood mostly cherry for cabinet frames and doors. Cuts were smooth and still looks new

Diablo is always a good blade. Consistent. No problems.

I needed a new blade, the Diablo was my choice and has worked great so far

Very good on hard wood!

I like this blade and would recommend it to anyone.

You can't go wrong with these blades. Great value for the price, and consistently delivers. I keep this 50T on my table saw and it handles most of what I am doing as a DIY/home owner. I'll occasionally swap blades if the occasion requires it, but it rarely requires it.

Great blade, using the Diablo 10” combination, makes me happy as a jackrabbit running up a hill.

Cuts like a hot knife through butter

Using it to cut through 1 1/2 acacia butcher block. No challenge at all. Easy cut, smooth finish, barely had to run a sanding block over the edge.

Nice blade smooth cuts

dependabe and great price

The Diablo 10 inch x 50 tooth combination blade is reasonably priced and gives me good results whether crosscutting or ripping. This is a thin kerf blade and is suitable for both hardwood and softwood. When cutting anything thicker than an inch I use a slow consistent feed rate to get a smooth cut from the blade.

I saw this blade recommended on a professional woodworker's YouTube channel as a lower cost yet excellent option to a $80.00 blade. I have found it to be EXCELLENT! Narrow kerf and clean cuts in both solid wood (ripping and crosscuts) and in sheet stock.