Customer Reviews for Glaze 'N Seal 5 Gal. Clear Wet Look Green Concrete and Masonry Lacquer Waterproofer and Sealer

Excellent product dries quickly, absorbs very well, looks wet, my patio looks beautiful, I recommend it 100% and the services in Home Depot it’s fast !

Bought this product to bring out the natural color of river rock in my backyard. Specifically ordered the “green low voc” version which isn’t sold in stores where I live, to reduce health risks to me and my garden. First of all, this stuff is VERY noxious (i wore a resipirator) so perhaps the VOC standards are only for when it’s dry, or its very misleading. Secondly, despite scrubbing clean all the rocks, within a few days on many of the rocks dried looking as though the sealant had separated from the stone, no longer leaving a “wet” or enhanced look. They look worse than before now, except the beautiful color doesnt even come out when the stones actually get wet, because they’re sealed. I wasted hours of time and am very disappointed. Perhaps the non “green” version works/lasts longer but when I called the company directly, they assured me the results would be the same for both.

This product was great! It glazed and gave my stone border a deep color and wet look. It has a strong odor so make sure you’re in a well ventilated area.

Way overpriced. Looked great all last summer thru fall. After 1 Oregon winter it’s gone.

Easy to apply,drys quickly, looks good.

100 SF paver patio. Two coats required two gallons to get ample coverage; I applied the product using Home Depot's 1 Gallon Pump Sprayer, and a large brush to even out the product once it was on the pavers. So far, product has dried evenly.

Works as stated, j used a one gallon pump sprayer worked great. I have sand joints about 1/8th up to 1/2 inch. Seems to seal very good. Nice and hard.

I was skeptical to give it a try having used other products in the past that were not satisfactory… Didn’t change the look no gloss… Milky film…This stuff is exactly what I was looking for… Only problem is it made everything else look terrible and now I need to do even more projects like Flagstone walkway… Slate patios…the attached picture shows the last few feet... restored a lot of the original color to my stamped concrete pool deck

I bought this to seal my brand new concrete driveway. Approximately 1200 sq ft. I used (9 in. x 1-1/4 in. Pro Super/Fab High-Density Knit Roller Cover) with the extender. Worked perfect. Applied two coats within 24hours. Used two 5gallon buckets. The and of results are awesome. Driveway looks very shiny and wet. Very happy with the product.

Look at the pictures below and you will see that this product can make a dramatic difference in the appearance of your stone or brick patio or walkway. This product is easy to use with a lambswool applicator and it spreads easily because it is thin. Depending on your surface it may take many coats to evenly cover the surface. I suggest wearing a vapor filtering mask because the fumes are thick, heavy and obnoxious. I used this product outside on my patio and had fans set up to blow the fumes away from me and this worked well. When I finished I threw away the brush, roller pan and applicator because I wouldn't clean them out with lacquer thinner because of the smell and dangers. All in all, this is a great product that did a very nice job bringing out the hidden color in my patio. I hope you find this helpful.

This product worked well. It’s easy to apply with a long roller handle. We have colored concrete that was applied by trowels, so it has a unique surface compared to flat concrete. The sealer makes it shine!

The results look amazing and what we were hoping for. We applied it to a paver brick patio that had never been sealed before. The first coat used more than we expected, but the 2nd coat used about half as much. For the first coat we used hand brushes to make sure we got into all of the crevasses. For the 2nd coat we used a roller.

I have a 900ft2 stamped concrete patio that needed a refresh. I lightly power washed one weekend and the next I used the Glaze and seal. This was not available in store Home Depot and I had to special order it. Coming in at close to $300, I was hesitant on doing so but the reviews were good so I took the chance. The sealer went on smooth using a high quality 3/4 NAP roller. My wife and I did this together and the first coat took about 1 hour to apply. The second took the same amount of time and I was left with about an inch of sealer in the can. Dried in about 45 minutes in low humidity 70*F day. Results were great but I do have some tips: 1. Go slow and let it soak in. If you go too fast, there will be spots where the sealer didn't hit. Going fast generates bubbles. 2. Wait for a cooler overcast day. My first coat was applies at about 70*F with no sun. Second coat was in mostly sunny and about 75*F. The sun dries the sealer quickly and it got sticky during application. So much so that the roller would "shed" and stick to the concrete. 3. Use a new roller for each coat. I even changed rollers half way through 1st coat. So the advertisement is correct, this will look "wet" when complete. Considerable sheen. It did get slippery in the rain or when wet so heads up on that. I could use a 3rd coat but I would run out of sealer. Next time I will order a couple extra gallons.

Very disappointed in this product as it looked great when we put it on, then it rained a week later. We have a cloudy looking sealer that looks worse than before we put it on. I emailed my complaint to the company but no response. What a waste of money, I will try again next year with another brand!

Worked great! Glossy and looks wet!

I applied the Glaze N Seal Wet Look to 900 sf. of colored and tooled concrete according to the directions and under the proper temperature parameters. I applied it with a roller and 5 gallon pail partially filled and used a roller screen so not to overload the roller. It's difficult to get the right amount to prevent it from puddling but still apply enough to get coverage. There were many irregular roller marks that freaked me out initially but they have mostly dissipated with application of the third coat. There are still some rather obvious ones left and some ugly puddle marks where I left a little too much on the second or third coat. It's hard to tell if there are puddles because it is shiny and wet looking after the initial coat so you have to be properly angled to see the sheen of the new application and by then it's too late to go back on it because it tacks up quickly. If you have a large expanse of concrete that you paid thousands of dollars for I suggest to hire an experienced applicator for this product and not risk subpar results. I'm surprised at so many positive reviews. I knew going in that it would be an ongoing maintenance issue and I wish I had just left my concrete patio alone after the pressure wash and not applied this stuff.

This is the product you want to go with if you are looking for a high-gloss, wet-look sealer. I used it to seal brick backsplash in the kitchen. It really enhanced the color of the bricks and sealed them nicely. Great product. Worth it!

Bought another brand first Stone Works Black Diamond wet look sealer. Absolutely did nothing. Wouldn't refund even though it said money back guarantee. I came across this product from great reviews . They were correct great wet look. Strong fumes for a few days though. Wear a mask and leave house to air out a couple days.

Great coverage and sheen. It worked out perfectly over my textured concrete overlay on my front porch.

Easy to apply dries fast and it brings out the color of the Stone

Very good product. Easy to apply

Super easy to apply and the results were exactly what we were after. Would definitely use this product again!

As indicated, the low VOC is much improved over the previous WET LOOK Lacquer sealer we used. It was easy to apply (suggest using an expensive sprayer), gave us the look we wanted, and brought out the color of the pavers. We're waiting to see how it holds up over the next 2-3 years.

After watching the youtube video (just search youtube for this name) i was convinced this was the perfect sealer for my slate tile floors and it was. It works just as shown on youtube! I used the suggested brushes from the video and application was easy, definitely where a mask and open windows. Took about 1.5 hours to dry (well thats when i tested it) i would suggest testint a small area or extra piece of tile as they REALLY mean wet look. My slate literally looks wet, so i wont be doing any additional coats. Im very happy though. I tested out other “glossy” sealers available at local home depots...they left streaks ans clousy grey areas no matter the application - when you looked at a particular angle the tile looked horrible! The others also werent very glossy at all! I hope this helps

Great product, but be sure to wear a mask as the lacquer sealer is very aromatic. Would also suggest if you are using a sprayer to use a high quality pump sprayer with brass fittings.

The wet look is a good finish look on the stamped concrete.

The product works and looks great.

Did my concrete driveway in the mountains that gets a brutal Winter, and it looks as good as the day it was poured. Great product and worth the money.