Customer Reviews for undefined

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Did not fit in guide slot until i sanded it down some

seemed to work as they should, the clamps were helpful in holding the track to a bowed piece of plywood to cut. Safer and easier that using a tablesaw

Beauty of the track is clamps not needed in all situations, but these fit perfectly under the track in the channel providing solid lock ,away from track guides.

Rating provided by a verified purchaser

Clamps work great. My only complaint is that they were screwed down so tight from the factory that they have indentations on the pads. Not sure if that will impact performance but would rather have a flat surface.

Rating provided by a verified purchaser

Rating provided by a verified purchaser

The clamps were exactly what I was looking for I bought them at a time when I needed them the most they work great

The clamps make cuts possible that standard clamps can't accomplish.

These clamps hold the track down nice and tight. The track saw is held in place without moving at all

I was surprised to find an over-all terribly rough surface on the clamps. They look cheap and the "unfinished" rough surfaces made inserting the clamp into the guide track difficult. They should cost $3.60, not $36!

The clamps needed a modification before they could slide all the way into the rail slot. I ground some on them and the slide in fine.