Customer Reviews for Milwaukee Carbide Glass and Tile Drill Bit Set (4-Pack)

Worked perfectly to drill holes in the tiles in my shower, I used the slowest speed on my drill and dipped the drill in cold water every 10-15 seconds to keep it cool.

This was the first time I’ve needed to drill holes in ceramic tile. I have lots of drill bits but nothing that would do this job until I purchased this set. I started by drilling a smaller hole in a spare piece of tile just to get a feel for how fast to go and how much pressure to use. The bits worked perfectly and not trying to hurry is the key. Stop occasionally to vacuum out the fine grit and dust. It was easy!

Would of been nice in a case

Used to install three safety bars in bathtub and it dulled and quit drilling after the first two. Taking them back today. Save your money and try something different.

Great for drilling ceramic & porcelain tile. Regular carbide tip bits will skitter across the face of the tile. These bits allow you to establish a clean cut exactly where you need it. Used these for shower curtain installlation.

Good stuffs

I used that on drilling holes on cheap tiles and none has broken. Good bits!

Used to drill a couple of holes through glass tile using a squirt bottle with some water to keep the dust down it went through it like butter don't be afraid to lean into the drill if your tiles are secure it won't shatter.

Worked great, would definitely buy again!!

Smallest bit broke off in wall after 3 holes. I used the bits on porcelain bathroom tiles and they did not hold up very well.

Did not drill through my porcelain tile as easy as I expected.

All the bits worked well at first but seemed to lose significant cutting ability after use on first tile.

These work well. Just remember to keep the area wet while using and they should last. I use them in glass tile

The bits didn’t last one hole before the tip ground down flat

Drill slow and with plenty of pressure and it’ll cut slow