Replace your sump and sewage pump switch with the Everbilt Vertical Float Switch. It's perfect for use in small pits or basins and conveniently includes brackets and clamps for installation to the discharge pipe. The universal design makes it compatible with all models with piggyback float switches
Approximately a 4 in. on/off span
On/off height can be adjusted by moving rubber grommet
8 ft. cord
Works with pumps up to 1/2 HP at 120 VAC and 1 HP at 230 VAC
115-Volt plug attached can be removed for direct wiring
Compatible with all models with piggyback float switches
Simple, works well. We've had an excessive amount of rain recently which always leads to some flo...
Simple, works well. We've had an excessive amount of rain recently which always leads to some flooding in the lowest corner of my crawlspace. I already had a manual pump but wanted something automatic in case I'm away. Mounting it required a simple modification to my existing pump -- I just tie-wrapped some pipe insulation around the discharge to make it large enough for the float to clear the pump body. Also added a tie-wrap to the float shaft so that it turns on at a lower water level. So far so good!
Easy setup, works great (it's been a couple of months since installation). Looks like it should l...
Easy setup, works great (it's been a couple of months since installation). Looks like it should last. I am giving 4 stars because unless the rod perfectly vertical the buoyancy of the floater tilts makes the rod bend a little bit, but maybe I am too much of a stickler. Anyway, you can bend the metal holding the head (if necessary) so that the problem is eliminated.