the problem with measuring this tool is that it gradually increases in width the farther up the tool you go (towards the attachment end) The end is less than 1/2 inches but this width increases to about 3/4 of an inch near the attachment end
This crevice tool is 10 1/2 inches long
approximately 1 6/8 inches plus/minus 1/16 of an inch (depends on accuracy of me and the ruler)
yes
I don't know what that model is. However, if the hose is 1 7/8 inches then this particular tool will fit
Hello Jim, It is not a requirement, however, if the job you're using the vac for requires vacuuming hard to reach places or tight spots, we recommend getting this crevice tool. If you have further questions or concerns, you may call our Customer Service at 1-800-474-3443 from Monday to Friday between 8:00 AM to 5:00 PM Central Time and we'll be glad to assist you. Thanks, RIDGID
This crevice tool will fit a hose that is 1 7/8 inches. The actual opening for this tool is approximately 1 6/8 inches plus or minus a 1/16 inch. ( not all rulers are accurate )
Buy it online at homeDepot
Yes, this should work. All 1 7/8 attachments will fit it.
Hello Ninbar Thank you for your inquiry about our products. We also offer 2-1/2 in. x 20 ft. Dual-Flex Tug-A-Long Locking Vacuum Hose (LA2522) and 2-1/2 in. x 13 ft. Dual-Flex Tug-A-Long Locking Vacuum Hose (LA2521) that you can connect to your hose using the Hose to hose adaptor from (VT1755) Adapter kit. These parts are available on this website where you can also view the price. If you have additional questions you may call our Customer Service at 1-800-474-3443 from Monday to Friday between 8:00 AM to 5:00 PM Central Time or send us an email at info@ridgidvacs.com and we'll be glad to assist you. Thanks, RIDGID