A: For an explanation and/or a recommendation, please contact our Technical Services Department at 800-438-6091.
by|Mar 15, 2024
1 found this answer helpful
Q:What is the actual ID (not nominal)? Will this work with the 1" Charlotte Pipe that has an actual OD of 1.125"?
by|Jul 31, 2022
3 Answers
Answer This Question
A: Yes
by|Aug 10, 2023
328 found this answer helpful
A: PVC dimensions are given like this because of the different thickness between schedule 40 vs 80 the inside demension is the same and 1" pvc pipe will work with 1" fittings schedule 40 bs 80 doesn't even matter for the fit bit for the pressure they can handle respectively. Hope this helps.
by|Aug 10, 2023
330 found this answer helpful
A: The OD of 1" pvc pipe is +/- 1.315 inches and the ID is +/- 1.049 inches.
by|Jun 8, 2023
327 found this answer helpful
Q:is the ID listed at 1" a nominal measurement or could I actually use this with a 1" wooden dowel?
by|Dec 22, 2020
2 Answers
Answer This Question
A: you are correct. the one inch is a nominal description. Charlotte Pipe products are designed for plumbing applications only.
by|Jun 8, 2023
327 found this answer helpful
A: It is 1" ID, but any irregularities in the dowel would have e to be sanded.
by|Jun 8, 2023
327 found this answer helpful
Q:Does the "SxS" indicate this elbow is "street" on both ends? That would mean both ends are a male connection, which is the same diameter as lengths of 4 inch pipe.
by|Mar 6, 2020
2 Answers
Answer This Question
A: "S x S" refers to " Slip (fitting) x Slip (fitting). I.e., not threaded. In plastic fittings this means one will be joining by gluing. In copper or brass plumbing, slip fittings (non-threaded fittings) are soldered - or, in the case of refrigerant lines, brazed. Sometimes in non-ferrous plumbing nomenclature the "S" designation is inferred to mean "sweat" or the designation "SWT" is used for the fitting end type. In ferrous piping, such slip fittings - either socket end or spigot end - would be welded.
by|Aug 10, 2023
326 found this answer helpful
A: The SXS refers to socket x socket and not street.
by|Jun 8, 2023
325 found this answer helpful
Q:this says 45 degree but it looks much larger is there any 120 degree connector
by|Nov 7, 2017
2 Answers
Answer This Question
A: It may look larger due to the enlarged photo. It is 45 degrees, and we do not produce a 120 degree fitting.
by|Jun 8, 2023
329 found this answer helpful
A: You can use 2 elbows to get any angle you want. To keep it small, use one regular elbow plus one "street" elbow. The small end of the street elbow fits into the regular elbow, avoiding the need for a small piece of pipe between the elbows.