Questions and Answers for DEWALT 18-Gauge Pneumatic 2 in. Brad Nailer with Carrying Case

A:  No.

A:  It can only use 18 gauge nails. It can use different lengths, from 1/2” to 2”.....

A:  No. Only 18 gauge..

A:  Hello and thank you for your question. The model DWFP12231 requires: Brad nails length 5/8'' – 2" (16 mm – 50 mm), 18 gauge diameter.

A:  18 gauge up to 2 inches long

A:  Hello Nachored, We're sorry to hear that the compressor is not building pressure. If this is a new unit, please make sure the drain valve is closed at the bottom. Also then turn the regulator knob to the desired PSI. If this does not resolve your issue please check instruction and troubleshooting on the manual or contact us at wecare@sbdinc.com and reference case #12983942. Thank you Deeris

A:  Hello Jim, Yes, a 200 PSI compressor is compatible with this model DWFP12231. Ensure that air pressure does not exceed recommended operating limits; 70 to 120 psi, (4.9 to 8.3 bar, 5 to 8.5 kg/cm2).

A:  Yes, the operating pressure for the DWFP12231 is between 70-120 PSI.

A:  Hi Mike, Thank you for your question. The model DWFP12231 nail specification is 5/8'' – 2" (16 mm – 50 mm).

A:  Yes it is oilless. PSI depends on what length brad you use. I generally have my compressor set to 100psi regardless but I think you could drive a 1 inch brad with as low as 50psi.

A:  Minimum recommended air pressure is 70 psi. I always operate mine at 100 psi. Dewalt says to not lubricate this tool. It is not needed, and keeps oil off of your work. This is an excellent tool, easy to load and adjust. I am very happy with it.

A:  Since they use small nails, they work well on lower pressures of 60 psi.

A:  Yes, the case is included.

A:  yes

A:  Bump shoot requires a different trigger, available from Dewalt. I have not changed mine. It seems like applications for this nailer are more likely to be where careful placement of the brad is important.

A:  The depth adjustment is on the gun. Not sure if halfway is possible. minor adjustment for the nail depth is possible. but not by air pressure. Insufficient air pressure can cause the nail to jam in the gun if it is not fully discharged. The head of most stick nails is only slightly larger than the nail. I couldn't even give a credible measure of the size difference.

A:  Yes it can be adjusted at the top you'll see it

A:  This gun requires an 18g nail....head size is set and just about 75% larger than actual nail size. Pressure changes will affect gun performance....mostly dependant of wood species but will only affect depth slightly. The gun has a depth adjustment at trigger...will set nail at maximum or just above flush....but a lot less than half-way.

A:  Can this shoot staples?

A:  Double check your nail gun. It comes with a guide. No issues with mine. Great tool.

A:  You should be able to get a manual from the internet. That said there is a tab on the front of the gun that will release the "cover" that covers the driving mechanism, there could be a bent nail lodged in the channel. That happens occasionally. I am also guessing that you might have gotten a returned gun, lack of manual, and it might be defective. I own one of these and it is one of the better nailers I have ever owned.

A:  No, my gun does the same. Put it back in the case and return. It’s broken/defective.