Questions and Answers for PRO-SERIES 6 ft. x 6 ft. x 2.4 ft. Multi-Use Drywall Baker Scaffolding with 1000 lbs. Capacity and Anti-Slip Platform

A:  It is possible but difficult to haul upper platform up. Also difficult to take apart without sections falling when anchors are removed. Call a friend.

A:  Indeed! But better with a buddy. And faster. And most importantly, SAFER!

A:  Yes, there is a video on how it can be assembled by one person. Always easier with two

A:  I did, I am in my 60's and a stroke survivor

A:  We recommend atleast 2 people.

A:  I did but I would advise two people. I was just in a hurry to get it up to get painting !

A:  Yes, it’s not ideal but it is very possible to put it together with a single person.

A:  yes no problem

A:  These are available for sale at the Vendor .

A:  1 11/16'

A:  Absolutely, I used it to fix the rain gutter for the 2 story house.

A:  Our scaffolding is all made for indoors.

A:  Good morning, Our scaffolding is 12 feet high. There is a typo on some websites. Our scaffolding complies with OSHA standards. As for specific state requirements , we are located in Missouri and are okayed to sell across the country. .

A:  It’s 136” to top of platform at its highest possible location. 

A:  We do not have information on any metal tech. Our scaffolding can be used with them You just need to get what measurements you need and compare them to what you have.

A:  Yes it will. I did it with mine.

A:  Most of our products are sold online . You can get them at any Major hardware stores.

A:  They have most the parts at Home Depot but most likely you will have to go to a few of them to get everything since the actual stores don't sell the set. I got mine online from Home Depot and it was cheaper then buying piece by piece.

A:  I do use the 3-Story scaffold with the guard rail system primarily for exterior projects and found it to meet my expectations. Since the ground topography varies I use the adjustable scaffold leveling jacks to adjust for the variability along with the adjustable outriggers to maintain stability. I added a 1 ¼ washer over the leveling jack wing nut screw to spread the load on the square scaffold frames. I found that the trap door floor not necessary but found it helpful to have two people to speed the assembly and disassembly process.

A:  yes

A:  Good morning, We have the TOWERINT unit that should be what your looking for.

A:  This scaffold weighed too much for me to assemble by myself. It is very well built, but I am 68 years old and hurt my back years ago. I can do a lot, but the sections were quite large weighing over 50 pounds each. Too much for me unfortunately.