Q:My customer drawer is 27.5" wide and 19.75" deep. What would Tray insert would you recommend for a cutlery tray?
by|May 6, 2018
1 Answer
Answer This Question
A: I suggest buying the 4WCT-1SH and 4WCT-3SH. Together these will give you the 27.5" you need.
by|May 5, 2023
Q:I have a 27" X 20" drawer need cutlery tray insert
by|Mar 7, 2017
1 Answer
Answer This Question
A: 27"W is a very large drawer. Your best bet would be to purchase 2 of our smaller version (4WCT-1SH) of this product which is 14 5/8" wide and trim each using a table saw to get down to 13.5". You would want to make sure to trim a little off of each side and to use a wood glue to combine them before inserting.
by|May 4, 2023
Q:What are the dimensions of the dividers for the silverware? My silverware is bulky and I want to be sure all twelve will fit.
by|Oct 30, 2016
3 Answers
Answer This Question
A: The smallest cavity is 2.4" wide which is a majority of the openings.
by|Jan 4, 2019
1 found this answer helpful
A: 27" X 20" What cost?
by|May 4, 2023
A: The center sections are 2.5" wide x 10.5" long x 2" deep. I have a Liberty Tabletop Sheffield pattern service for 12. The pieces are about as fat and heavy as I have seen anywhere. The knives do fill one cavity but they all fit. The rest of the cutlery fits easily in the cavities. If you were to divide the knives between two cavities you could probably fit a service for 24.
by|Jun 4, 2023
2 found this answer helpful
Q:can this be cut to fit in store
by|Mar 18, 2016
1 Answer
Answer This Question
A: I am not sure. You will have to contact Home Depot directly. I'm with Rev-A-Shelf and I think it differs from state to state
by|May 3, 2023
Q:looking to fill a 19 3/4d X 25 1/4 w drawer
by|Oct 30, 2015
1 Answer
Answer This Question
A: This is the largest size available for this unit. Since the units can be trimmed to fit the drawer, you may consider purchasing two of the smaller units. Model # 4WCT-1SH Internet # 202855489
by|May 3, 2023
1 found this answer helpful
Q:I have a 16 inch drawer, which one should I get?
by|Oct 28, 2015
2 Answers
Answer This Question
A: Hard to say - if you buy the large, you'll be cutting off 6 inches in width, if you buy the small, you'll be short 1 1/2 inches. I'd go for the small as there is no natural point at which to make the large one narrower. And you can always return it if it doesn't work. In my experience Home Depot is very good about accepting returns.