Customer Reviews for JELD-WEN 24 in. x 80 in. No Panel Unfinished Flush Hardwood Interior Door Slab

Served the intended need.

I used this to make a desk by laying across 2 2-drawer file cabinets. Worked perfectly. Has a nice finish that I haven't decided yet whether to pain or stain.

needed a pocket door so this was the default immediately available door nearby. Front and back finishes were very nice and took stain well. The edges are not very finished and took stain differently. The glue under the label must have had a residue left over as there were a few small spots that wouldn't take stain. The label didn't peel off easily either. This is a hollow door, and installing the pocket lock exposed a lot less wood frame than the damaged door it was replacing, and the door dress panel itself is mostly cardboard with a thin veneer over it. Product could be improved with 1) finished long edge (at least one) 2) neater label removal 3) small cardboard protector caps over top and bottom (some minor damage from in-store handling was noted on the edges)

100% cardboard with almost a 1/32 veneer. Very overpriced.

Several of the doors that were in stock were damaged. I bought one and didn't notice the dent until I got it loaded into my car. Had to haul it back into the store and try to find another one that was in good shape.

This is a basic low cost door I use for a closet. Nothing fancy but it has served its purpose well.

The faces of the door are a thin cardboard-like material with paper thin veneer which contained voids. These became very visible upon staining. The top & bottom edges of the door are supported by a thin cardboard strip. The side supports are an engineered wood product which is full of voids & does not hold screws very well. Overall, a terrible product!

I need to return this too small

Horrible cheap junk, don't waste your money.

Good indoor blank slab door. Easy to size, finish and install.

Fast and in good condition.

Would have been excellent if the doors matched in grain.

Worked as expected, just wish I could have gotten a couple more.

as many reviewers have noted these are thin and hollow. And so if you cut more than 3/4 off the bottom or 1/2 off the top, you have to rebuild by cutting a piece of wood to fit in where the cardboard was and glue it in. Very annoying. But it says that on the instructions, so just be forewarned. And the veneer is very thin, too. And so if you even let a power sander anywhere near it, watch out. BUT, with clear Danish oil they varnish beautifully and give just the right mid-century look to my 1960s condo, for a very low price. I was replacing equally cheap particle doors with many coats of generic white paint, so these look so much better. Hope this helps.

Awful door. I had no idea they weren’t even wrapped, they looked awful and I promptly returned them the next day.

Had some dents in it, which was fine for making a desk top but wouldn’t want it for a door.

It was actually larger than 24 inches and the door won’t close.