Customer Reviews for Lithonia Lighting 3348 2L32W WRAP 2-Light White Utility Light Wraparound

Easy to install, very bright

It was more expensive than it should be for a basic florescent light but it works well.

Exact replacement I needed.

Exactly what i was looking for!

Installed this unit November 2021. Since then the diffuser has fallen out three times, the last time breaking off a large piece of one end. It seems to be too short, so if installing be sure to either tape or silicone the diffuser in place.

Purchased to replace existing units with spent ballasts. Unlike my old lights, the new ones do struggle to start being used in our basement which is cooler but they do eventually come on.

Was exactly what was needed. Quick to install and bright lights.

A basic T-8 light fixture. Works fine - construction is light weight. Finished installing the first one - walked away and the "diffuser" (AKA plastic glass) fell out of the housing, fell to the floor, with a corner piece smashing into small pieces. Employee said I can order a replacement on-line - but unable to see it listed. Still need to follow-up with this. Installation tip: carefully bend the clips at the end such that they give a sturdy hold to the diffuser. Also I opted to use my own set screw wire connectors rather than the light-weight standard ones supplied (which was missing one anyway).

Nice T8 lighting. Fitted them with 'Daylight' bulbs. Very bright. Easy to install.

The light worked perfectly and i was pleased.

Real simple to install

Very easy to install. Wired it up, used 3 screws, all done. Took about 5 minutes.

If you order 3 lights home depot was to give a extra 10 % off which they did not.

The light fixture installed nicely as expected. BUT the plastic cover does NOT fit the fixture. It is a bit too short.This is the second one I have purchased with this problem. To hold it securely in place I am using clear duct tape.I bought these fixtures because they were low cost and they do work. So be warned.

the frame of the light was “stretched out" a bit and would not catch the dispersing cover. I am holding in with paper clips. Jack