Customer Reviews for M-D Building Products 1/4 in. x 3/4 in. x 10 ft. Black Sponge Window Seal for Small Gaps

It does the job purchased for

I really wanted a narrower product but Home Depot did not have it so I had to cut it to size to go around an exterior window screen.

Same complaint as my other review.

Perfect I was worried window may not close all the way or stop draft. This foam can squeeze all the way to allow gor window to close or fill gap

It falls off too easily.

Didn't stick right away, fell off the door frame.

Great product easy to apply and it worked to perfection

Adhesive was exposed, not under the removable tape. Adhesive was dried out and did not adhere to surface even after a full surface cleaning.

This is to replace that supplied with the LG portable Air Conditioner for fitting the window panels through which the hot air exhaust flows. The originals had worn out after several years' use.

Worked great, seems durable

Good stuff. It's much better than the 'good' grade.

Worked good for what I needed. Spongier than I expected but adhesive was good

Would not stick. Didn’t work for us.

Could not get it to stick - the adhesive is awful and so poorly distributed on the strip. Ended up throwing it away!

Poor adhesive, fragile, junk

Even after prepping surface with rubbing alcohol, this doesn't stick. Immediately peels off within minutes. Absolute garbage.

Used to seal lazarrette seats on the cockpit of a boat. Cut to size, peeled off backing from foam tape, then placed onto clean inside surfaces of fiberglass seats. Hardly stuck in place at all. Will have to use contact cement to do proper job. Otherwise, will have to throw it away.

The adhesive is weaker than the adhesive on a Post-It note. Doesn't stick to anything you'd actually want to stick it to. Applied it to the side of a door trim, started at the top. By the time I got down to the catch, the top had already fallen off. Tried again with a fresh piece. Same result. Disgusting, this trash is going back. It's probably a fine seal, so the seal part isn't the problem. It's the total lack of real adhesive.