Customer Reviews for Mighty Mule Security Gate Operator Pin Lock for Mighty Mule Gate Openers

Easy to install and it was great that it included four keys so that each of us have on in case of power failure

These locks were well thought out!

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Very easy to install and comes with 3 keys which makes it nice for a larger family. Don’t have to immediately spend more money making keys.

Lock locks gate as intended

As pictured

This was just what I needed to secure my gates. It’s a bit expensive but worth it for being able to secure my yard.

It looks to be a good product but the pin was too short for what I needed.

works great, no problems. thank you

Nice lock to deter theft of your gate opener .

works great thanks

It does what it's supposed to do.

Mike Great product works great

worked perfect thanks!

great for me

The whole installation did take a while, and there were a few minor tweaks, but we have had it almost 2 weeks now and like it very much

Works great

Lock works fine. The holes on my mighty mule gate had to be drilled out because they taper and the lock would not go all the way though.

I placed the pin through the eyelet at the end of the gate opener. Then I struggled for quite some time, trying to get the pin to engage fully into the lock. The pin would not go through the manufacturer's gate opener bracket far enough to allow full engagement. I finally used an available tool to beat on it enough to lock in. I wonder if I'll ever be able to get it off now?

Works as described.

Easy to Install.

Wanted 4 with the same key. Have to look for others.

These will make my opener much more tamper proof, and give peace of mind.

The pin lock did not fit the FM350 bracket. The hole in the bracket seemed to taper slightly (as if it had not been bored all the way thru) and with the diameter of the lock pin slightly larger than the original clevis pin I had to enlarge the hole in the bracket. Since only one other person mentioned this problem in a review I guessing this is not a common issue. Once the hole was resized the pin fit and does the job.

Purchased this for my mighty mule gate opener great added security for the opener. Would highly recommend as openers are costly to replace.

To thick could not use, would not fit through the hole

I needed four of these to secure my dual opening gate. It would be nice if there was an option to have these keyed alike since even a single opening gate takes two. Having four sets of keys to keep up with and try out on each lock should I ever need to unlock these is a bit much.

It serves its purpose, but the quality of the lock is poor.

After completing the Mighty Mule 500 on the driveway gate, I figured that I needed the pin lock to finalize the security. I purchased TWO lock pins - one for each side of the Mighty Mule. The instructions booklet specifies the pin on the GATE END of the system only but the same pin technology is used on both ends, so I replaced both.