Customer Reviews for UltraTouch 48 in. x 75 in. Denim Insulation Hot Water Heater Blanket

Performs exactly as recommended, great product!

My first reason for choosing this product was because it does not contain harmful chemicals. The insulation was simple if you have another set of hands. I suggest you use a strong plastic tape to hold it in place and then put the silver tape that is provided on top of your tape.

I’ve purchased two of these and neither one was close to the stated dimensions of 75 inches by 48 inches. Neither one exceeded 62 inches. Off by more than a foot? This company sucks.

Very high quality material. Provided tape worked very well. Only complaint is my cat likes to claw at the reflective surface causing it to shred. I would recommend denim insulation over fiberglass.

Easy to wrap around the water tank and make secure

This hot water heater blanket was easy to install.

Works as Described Helps keep the Hot Water Warmer in between Regulated Heat settings.Builder build the home with the Hot Water Heater in the Garage.That was Dump...Will Save on Heating Cost eventually...

Easily installed and works great

Rating provided by a verified purchaser

this barely able to fit, needed a lot of tape.does not fit most!!.left at least 12 in open on bottom of elect heater

MAGA! easy to wrap & looks good. Tape has held, but to early to see how much $$$ saved since installing. 30-40 degrees in the garage, but the water heater has her jacket on staying warm. KAG!

Rating provided by a verified purchaser

Recycled material. Does not itch.

Excellent product and very easy to install. I like that is was made from recycled denim materials and had highly reflective thermal skin. The best part was No Fiberglass.

Great water heater blanket

Rating provided by a verified purchaser

It was difficult to cut and required a lot of tape to secure in place, but the insulation did not irritate the skin like fiberglass does. I would buy it again.

The hot water heater blanket was easy to install providing for good coverage of the tank. The only issue I had is that it did not completely cover my 50 gallon tank circumference. I was able to make it work by strapping across the front leaving easy access to thermostat and heater element panels. I would recommend it as a real good value for the price for smaller tanks. I would not recommend it for any tank over 50 gallons.

Rating provided by a verified purchaser

It didn't really fit the water heater. Even though y'all said it would fit a 60 gallon heater. My water heater is 58 in around and 57 in tall so but it's good I like it I finally got it on there.

It was a perfect fitting and all we needed to finish the job was some duct tape.

A must have for any hot water tank. relatively easy to install. The main issues are that the aluminum tape provided tears easily, and the sheet when rolled out is not exactly rectangular but rather a bit trapezoid in shape due to the way it’s packaged. The instructions could be better.

It was very easy to install. It does help keep the water hot longer and saving on energy costs.

Easy and quick installation, but frustrating that the dimensions are not as described. The one I received is only 67 inches in length. The width was pretty accurate.

Product was good quality

A little small for for a short water heater

Excellent product!

great price, free delivery and quality material

Perfect fit!

Rating provided by a verified purchaser