Questions and Answers for Alexandria Moulding 105 3/4 in. x 3/4 in. x 96 in. Primed Finger Jointed Quarter Round Moulding (1-Piece − 8 Total Linear Feet)

A:  Thank you for your inquiry, Aisha. This primed finger jointer quarter round moulding is most commonly used at the base of the floor. To calculate what is needed, you will need to know the linear footage and not the square footage. For example, if you have a 10ft x 10ft room, you would need 40 linear feet of quarter round.

A:  Thank you for your inquiry, Kyle. The species of wood is Poplar. It is painted finger jointed poplar.

A:  Thank you for your inquiry, Mare. To successfully determine how much quarter round is needed, more measurements would have to be supplied. Please refer to the home improvement ideas page on homedepot.com for more help: https://www.homedepot.com/c/ab/types-of-moulding/9ba683603be9fa5395fab905aac6715 or speak to a store associate for more assistance.

A:  90 linear feet. These are 8 ft lengths and a carpenter knows how to join them as needed.  90 /8= 11.25 so I would purchase at least 12 of them. 13 if budget allows for mistakes.  You can usually take back unused full pieces. 

A:  Hi Carol. You will need 12 pcs for 90 linear feet plus off-cuts. Hope this helps.

A:  Diveide it by 8ft then add 10% for missed cuts, wastage. Get 12pcs

A:  Seems like semigloss. It’s not flat. We painted glossy anyway as they can get some blemishes on them with handling.

A:  Hello EK, thank you for your inquiry. Our DecoSmart Paint has a gloss between 15 and 20 degrees measured using a 60 degree gloss meter. It would likely be considered a Satin finish. For touching up the nail holes they can use our DecoSmart Filler (ST009-00C). Thank you.

A:  Hello KKoz, thank you for your inquiry. The preferred tools for nailing quarter round is an electric finish or brad nailer fitted with 1.1/4" – 2” finish nails. Choose finish nails that are long enough to penetrate the thickness of the quarter round, baseboard and the drywall with enough left over to go at least 1/2 inch into the wall's base plate. We hope this information helps in the completion of your current project.

A:  1 1/2 long

A:  Hello Stacey, thank you for your inquiry. If you are installing this item at the base of existing baseboard you will need to miter the corners to connect. However, if you are installing new baseboard and quarter round you can use inside and outside base corners to avoid miter cuts. We hope this information helps you complete your current project.

A:  Primed only

A:  This moulding is painted.

A:  Hi AL61, thank you for your inquiry. This item is painted for ready to install moulding. We hope this helps.

A:  It is just "primed" but it is so well primed you can get away without painting it if you arent too picky.

A:  It is just primed.