Customer Reviews for 1 in. x 12 in. x 6 ft. Premium Kiln-Dried Square Edge Whitewood Common Board

Board was mostly flat (slight bow on one end) and corners are square. Board was clean with no splinters. Some sap on the ends, not visible but just enough to feel.

I am a big fan of the raw unfinished look of wood and I like to use these common boards for shelving. Because they are kiln dried I run into very minimal warping and the board is straight for the most part. Easy to cut if necessary and easy to run a router if you are looking for a fancier finish

I purchased two of the boards for a console table that I built. Usually I go with shorter in width, but I decided to go wider this time do I went with the 1x12. The boards come with its imperfections but it’s very good for the price. Easy to sand and the wood grains pops out nicely when stained.

Not warped, no chips and some beautiful knots. Perfect for our window valances.

Beautiful!!

Great value for the money

Good

I don't use a plank this wide very often during my projects, but I needed this for a bed I am making. First it matched the other wood I am using well, I also did a test stain on it to see if it would take the stain I am using on this projects and it did do well there also. So far I have cross cut this board, ripped it and used two router bits on it and it held up well with minimal chipping. Believe this wood is as good as you would expect from a soft wood.

Good board for general purpose use.

only complaint is the boards have the gummy center and when it's cut out the outside edges bend in toward the center

Very heavy duty. I used this to make a garage shelve and coat rack. Mainly I made this for my motorcycle leather and gear which is heavy due to armor and being thick leather. This does a great job and handles the weight with ease.

Had a few knots, cut around them; ok for small projects, commesurate with price.

In the process of making a keyboard stand. Hopefully if nothing comes up I’ll be done in two weeks.

Light but sturdy. Perfect for my closet shelf.

Had to go through quite a few boards to find the one that I bought this one still had some cupping if I had a planer that would’ve taken care of that issue

I liked the look of this common boards but I made the mistake of basing my measurements on the description of the board. I used it for wall shelves. I cit my support sides 12 inches long. When I placed the tops guess what??? the actual with is 11 inches. Not 12 inches as stated in the description. Now I have to figure out how to fix one inches missing on the back of the self. Beware of actual measurements as opposed to stated measurements.

Found a nice piece of wood. Looks good.

The lumber worked out great! They were straight and were perfect for a shelf.

was able to get enough knot free wood from it for my project.

Even though I paid the “Premium” wood price for this board, it still pretzeled up like the standard-priced lumber in your store. I know you can’t expect the same quality of lumber as found at a woodworking store. Never enough time needed to properly kiln dry the wood. So just don’t mark it as “Premium” and ask a higher price for it.

Horrible wood. Warped and pulled molly’s out of the wall. Returned and purchased a different one, slightly better.