Customer Reviews for Amerimax Home Products 3 in. x 10 ft. White Vinyl Drip Edge Flashing

Good for what I needed...cut easy install easy light weight so I didn't have to struggle on the latter...it won't rust ,won't peel ,wont fade...&u can paint it...if u desire...

The Edge Flashing was easy to install and works great!

Good product

worked great.

Great quality.

Very easy to work with...

Great for extending drip edge over new fascia board without having to add new shingles.

Rating provided by a verified purchaser

Very easy to install and it is good looking with vinyl gutters

Had water leaking into the shed. This item did the trick. Water stopped coming in and the inside walls are drying out.

What can ya say, it does it’s job

I am in the market for some more of this. I installed this for the same reason another customer stated: after installing gutters the roof dripped between the gutter edge and the fascia and this product solved the problem. I am replacing this due to it becoming warped over time, but was still working fine. I will install the new stuff with sealant instead of staples that I used with the old stuff. It is a good product for inserting under installed shingles.

reroofing a house and purchased 45 pieces of this drip edge. happen to have two pieces from a reroof job 9 years ago. the old stuff is much stronger-thicker rolled metal. I just wonder how CHEAP can you get the only reason I would recommend this is that there is no alternative for $5.50 pce. with tax.

The product worked fine but it looked horrible being dirty and bent in places from wherever it was stored at Home Depot! But it goes on the roof over the gutters, under the shingles and it works.

I installed new gutters, and was dismayed to find some water bypassing between the gutters and fascia. This product slipped right in, and solved the problem. Regarding the other review that complains about no explanation on how to mate two pieces; just use some sealant. If you feel the need to overlap the segments, then just trim the lower protrusion off (snips) so the top section will lay flat. Even with an overlap, I'd still want a bead of sealant.