Customer Reviews for Avanti Pro 7-1/4 in. x 140-Tooth Hollow Ground Plywood Saw Blade (2-Pack)

I reversed the blade as instructed and cut Suntuf panels very cleanly. I clamped several panels together and cuts were clean with no cracks or chipping.

First of all the sticker on the blade they tell you to remove must have been put on with super glue. Why the intense sticker? Next the blade burned when I tried to cut 3/4" plywood I had to switch back to my framing blade.

Still gives lots or tear out. Will cut wood but you get what you pay for.

Used it to cut 1/4" birch plywood. Worked great! Nice clean cut.

I used this blade to cut Suntuf corrugated panels. It worked well and did not split the panels.

I wasn't expecting miracles from this blade but I would have expected it to perform better. The blade is extremely unbalanced creating a hard vibration in the saw. The tear out with this blade going at a reasonable speed is worse than if you used a framing blade. You can reduce the tear out by slowing down but expect it to burn the edges.

It gets dull so quickly. I cut about 10 inches into a 3/4" MDF then it just won't cut anymore. I couldn't returning it in the store because the barcode on the item was different from the one on the receipt. There goes $10 that I should've spent on a better brand.

It's a ply wood blade itbis what it is I use backwards from vinyl

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Rating provided by a verified purchaser

These blades cut great. The plywood I have is fine hobby grade and has very little splintering.

Worked great for fine cutting

Good deal for two good blades. Thank you!

Cut my plywood like butter. Nice smooth edge.

My cuts are smooth and accurate. These are inexpensive blades so I don't expect them to last for an infinite number of cuts. I recycle the metal and put on a new one when it looses it cutting ability.

Rating provided by a verified purchaser

Tough as nails and sharp as a razor, this blade flows through 3/4-inch plywood like a hot knife through butter. It’s A must-have blade for your circular saw, and it’s a great price, to boot!

Rating provided by a verified purchaser

Sharp blade. Smooth cuts with little or no splintering.

It just does not work. It burns the wood and does not cut it. I even tried to cut MDF but it did not work. It did not work on laminate flooring either. It was a waist of money!

Didn't last very long. Got so dull the saw was working very hard.

Rating provided by a verified purchaser

Cut good, but got hot quickly and would not hold the line.

Used this blade to cut eighth inch paneling, and it hardly would cut it the blade is junk don’t waste your money

Rating provided by a verified purchaser

Not a fan of this blade at all. Picked one up to try given the cheap price, but was very disappointed. My first attempt using this blade was to cut plywood for cabinet boxes - it failed miserably. I didn't expect it to be great, but the blade consistently deflects by an 1/8" on cross cuts (which is not acceptable for cabinet building). My second go round with this blade was on OSB subflooring, again it did a poor job. While the cuts were clean you had to go so slow it almost always started to produce some smoke. This really don't have a place anywhere in my book except for maybe 1/4" material, but even then I would go for a better sturdier blade. Simply put, its too flimsy for accurate cuts, and it does not cut fast enough for doing rough subflooring or sheathing.

Rating provided by a verified purchaser