Customer Reviews for Everbilt 1/4 in. x 1-1/4 in. Hex Zinc Plated Lag Screw

This lag screw has few vices. In fact, I used it to secure a vice to my workbench. Arguably, that's its only vice.

Its a lag bolt. It fastened the hose reel to the wall.

Great, solid product

Good product. Not overly expensive.

Very good lag screw that worked well for my project. A couple of reviewers complained of these being weak and breaking but I'm not sure if they had a bad batch or if their pilot hole, assuming they used one, was the correct size and the right depth for the type of wood receiving them. Check your wood type and get those issue right and you shouldn't have any trouble getting these fully seated. If the hole is too small or not deep enough, the friction may be too great and they can shear off as I've learned on past projects.

It's a lag screw what is there to review? haha

Exactly what I needed to replace product screws for Polywood chaise lounge that kept stripping.

Its a screw. A single screw. It worked as well as a screw should.

Exactly what was needed for the project and still holding.

Just what I needed to do the job.

Good product that works well.