Applied it at 72F, using the supplied mixing tube. It is still tacky after 2 hours. Warming it ...
Applied it at 72F, using the supplied mixing tube. It is still tacky after 2 hours. Warming it up to see if that will help it cure. No Best Before date that I can see on the packaging. Called customer service line but "high call volumes" and asked to leave a message.
I used tons of Henkel resin in manufacturing and they were always superb so bought this over the 25% cheaper brand beside it. Made a poor choice there.
by
Response from Henkel CorporationAug 5, 2021
Thank you for the feedback. The epoxy will need 24 hours to fully cure.
Nov 10, 2017
4 Star Review
Rating provided by a verified purchaser
by
Verified Purchase
Nov 7, 2017
Bought this to hold a metal grill to fiberglass on my RV. Certainly did not work in under a minu...
Bought this to hold a metal grill to fiberglass on my RV. Certainly did not work in under a minute. Left it strapped with tie wraps overnight, then a few spots held. Even then, they broke after a few hours on the road.
by
Verified Purchase
Oct 27, 2017
It did “dry” in about a minute, and then stayed...
It did “dry” in about a minute, and then stayed tacky for the next three days. The good news - it was relatively easy to peel off.
by
Verified Purchase
Oct 25, 2017
4 Star Review
Rating provided by a verified purchaser
by
Verified Purchase
Oct 11, 2017
4 Star Review
Rating provided by a verified purchaser
by
Verified Purchase
Oct 11, 2017
5 Star Review
Rating provided by a verified purchaser
by
Verified Purchase
Oct 4, 2017
I am in the commercial repair industry. I always make...
I am in the commercial repair industry. I always make a point to keep this on hand! Of course, you only get two applicators. SAVE THE UNUSED ONES!!! They come in handy later on when you only need to use a little bit of it but have to waste and entire applicator tip!
by
Verified Purchase
Sep 20, 2017
OK
OK
by
Verified Purchase
Recommended
Sep 7, 2017
Used twice. The glue inside both mixing tubes cured. A...
Used twice. The glue inside both mixing tubes cured. A cap for the remaining product would have been welcomed. If I need to buy more, I'll choose an alternative product. Works well, but packaging makes lots of wasted product..
by
Verified Purchase
Sep 5, 2017
It took a lot longer then 1 minute to set...
It took a lot longer then 1 minute to set and when it did it was rubbery and the item I was trying to glue kept falling off.
Very disappointed with this product. I had to go to a competitor to buy something that actually worked.
Thank you for the opportunity to review.
by
Verified Purchase
Aug 22, 2017
Worked just like it's advertised to...
Worked just like it's advertised to
by
Verified Purchase
Aug 16, 2017
Great product. ...
Great product.
by
Verified Purchase
Aug 15, 2017
worked great, only one complaint. Only two distribution tubes came with it so if you don't use it...
worked great, only one complaint. Only two distribution tubes came with it so if you don't use it all in two needs it will go to waset
by
DIY
Verified Purchase
Recommended
Aug 15, 2017
Worked great. ...
Worked great.
by
Verified Purchase
Aug 2, 2017
Just dries slower than I expected. about 5 minutes to start to set. Otherwise its great. Forgot t...
Just dries slower than I expected. about 5 minutes to start to set. Otherwise its great. Forgot to mention the smell is kinda strong.
by
Verified Purchase
Recommended
Aug 1, 2017
Hardened
Very hard to use and it hardened up so fast should have better directions in use of this product
by
Aug 1, 2017
This stuff sets up way too fast. I tried...
This stuff sets up way too fast. I tried to glue two spindles and had to stop after the first one long enough to tighten the set screw on the base (15 seconds Max) I went to glue the second and the epoxy had hardened in the tube end. Hardly any working time. Once the tip is installed you have to glue everything you want glued with no stops. Two spindles = 2 tips = a lot of wasted epoxy.
by
Verified Purchase
Jul 19, 2017
Easy to use & fast dry...
Easy to use & fast dry
by
Verified Purchase
Jul 18, 2017
Did not set properly or hold the bond on the...
Did not set properly or hold the bond on the plastic drawer bracket I tried it on.
by
Verified Purchase
Jun 27, 2017
The mixing tip broke at the connection junction, the epoxy...
The mixing tip broke at the connection junction, the epoxy went all over and it was a mess. It turned out to be very messy and they should improve the strength of the connection from the tip to the holding tubes.
by
Verified Purchase
Jun 27, 2017
Works exactly as advertized.
Works exactly as advertized.
by
DIY
Verified Purchase
Recommended
May 31, 2017
this product worked great for me. did everything that I wanted it to do. very easy to use and see...
this product worked great for me. did everything that I wanted it to do. very easy to use and seems to be very strong. I will use this product again.
by
Verified Purchase
Recommended
May 25, 2017
The epoxy works great. I used it to bond a plastic door latch to the side or our RV. The short se...
The epoxy works great. I used it to bond a plastic door latch to the side or our RV. The short set time made it possible to just press the latch in place and hold it there until the epoxy set. The kit comes with two mixing nozzles so you can get two "mixes" and two applications. but unless you are planning on two mixes in the same day or so, the kit is small enough and cheap enough to just toss the kit after the first use and get a fresh kit when the need arises. If you have never used a two part epoxy before, give this a try. The quick set, superior performance will make you glad you did. The mixing tip is a little tough to install but if you have a normal strength grip in you hands and fingers, it is manageable.
by
Verified Purchase
Recommended
May 20, 2017
I needed to glue a glass bowl to a metal...
I needed to glue a glass bowl to a metal base of a bird bath. This glue did the trick and seems to be holding well.