Customer Reviews for Plytanium Plywood Siding Panel T1-11 8 IN OC (Nominal: 19/32 in. x 4 ft. x 8 ft. ; Actual: 0.563 in. x 48 in. x 96 in. )

Decent product, while this doesn't have the water and fire resistance of its' cementitious counterpart its' resistance to damage from rough handling and being able to modify it with basic carpentry tools make up for it. Does have some weight to it but a busted corner is unlikely. Other than natural discoloration has held up well with out being painted/sealed. Shed built from same product is going on 6 years old .

Worked great and matched my other siding

Sturdy exterior , painted easily

six or seven of the T-111 were coming apart on the edges or the T-111 was missing from sections of the boards. There were bubbles on areas of some boards as if it was left out the rain and came unglued from the backing board. These problems slowed my project down considerably, because in areas where I could use wood glue and a patch over the defective area had to dry over night. Out of the 14 sheets of T-111 7 were in need of repair, very poor quality.

Purchase in person and you'll be happy. However, I have ordered 3 deliveries of this plywood and each had over half of the order damaged, split or had stain sprayed across the show side; I felt they were unloading their B-Stock. Also, of only a few are damaged they won't take those back; you must refuse the entire delivery of everything ordered. Then the return process was terrible. No replacement delivery is possible until you arrange pickup with the damaged goods and no refunds are issued until they pick it up and deliver that material to the store.

Coarse surface makes painting difficult as multiple coats are required to seal the facing.

Rough surface and edges compared to competitors Plus more $

Perfect for my needs, I used it to enclose a lean-to section next to my garage.

New bundle and had staples in the top two sheets that I didn’t see till I was home or I wouldn’t have gotten those two

The price was excellent but overall quality was less than average. Both side of the ship lap were not milled properly. I know HD does not mill it but the accepted or purchased this sub standard lot

Great material great price

Despite it being heavy, it went up quickly and looks great!

The t111 siding was junk , I paid for 2 good quality sheets and what I received was terrible, lucky I didn’t need a perfect 4x8 sheet! The turned the bad sides down on my trailer, the phone service when picking up my order was terrible, had to talk to 3 different people which all of them said they would be right out! I took approximately 35 minutes! The Home Depot in St Augustine is more professional! I learned my lesson on the quality I received!

Worked great for my utility shed project

The finished siding job was acceptable but the material was difficult to work with. It would not lie flat, slightly convex. This made using a chalk line or long straight edge problematic. It took 2 workers to snap a simple line, one to put weight on the center of the siding to flatten it. I need to make some barn doors and was hoping to use the T111 but due to its stubborn curvature I’m hesitant to try it.

The piece that was pulled for me was in terrible shape. I should have returned it but the service I got when picking it up was pretty terrible so I didn’t trust I was going to get much better.

Panel is just right, am making new door for shed. Panel plus 2 x 6 makes for very solid door.

Semi-erect warped sandpaper. Arguably the worst material in the galaxy.

Lots of voids and delaminates too easily. Quite poor quality. Difficult to paint because of how rough it is and how many voids there are in the cut grooves. Will never use this terrible stuff again.

Very rough cut with lots of splinters. Be sure to use gloves. Definitely not a flat piece of wood but bowing was greatly reduced by a day in the sun on the driveway