Customer Reviews for Varathane 1 qt. Clear Gloss Oil-Based Interior Polyurethane

'm restoring an old oak table and was disappointed my home center didn't carry a well known stain and polyurethane applications. I bought Varathane and I'm very proud of the results. it's now my go to brand. it goes on easy and dry fast. the table never looked better. highly recommended.

I'm restoring an old oak table and was disappointed my home center didn't carry a well known stain and polyurethane applications. I bought Varathane and I'm very proud of the results. it's now my go to brand. it goes on easy and dry fast. the table never looked better. highly recommended.

Gave a good clear finish,easy to spread,went on smooth with a nice gloss finish.

Polyurethane makes a great sealer to protect your wood floors, table, and other wood furniture. I stained an old table and then put 2 layers of Varathane Ultimate Polyurethane to reinvigorate an old table.

Easy to apply. Great end result.

This product did an excellent job and performed as expected. To save yourself a lot of extra work read the label carefully as it indicates you should apply a coat then wait up to 4 hours before applying a second coat and three coats are recommended. If you wait past 4 hours you have to re-sand the entire surface before applying the next coat. I missed that when I applied the first coat, waited a couple of days and then created extra work!

I placed accent walls in my home and used Varathane Ultimate Polyurethane Oil Based Clear Satin to finish the walls. The results have been phenomenal! It takes 3 coats to get the finish that I wanted, however, the directions on the can stated it would. Each coat takes about 4 hours to dry before recoating. Great product!!!

i too experienced the shiny orange peel finish. it goes on very thick. and dries like wood glue in seconds. i will buy another quart som my project is uniform. I dont recommend this product. it looks terrible.

I wasn't too sure about it. I was looking for Minwax, which I have always used, but then remembered HD doesn't carry it anymore. I've heard of Varathane but never used it. Very pleased. I just wish I had sprayed it instead of brushing because I got quite a few brush marks but that's my fault not the poly's fault.

Absorbed quickly into dry wood, best with a minimum of 3-4 coats.

I wish I would have read reviews prior to buying this product. Each coat of this product dried unevenly. Some areas were glossy, some flat. Brush strokes show up as well. I went intending to buy Minwax, but this was the only polyurethane available at Home Depot. I spent hours refinishing a dresser, and it looks terrible. Never again. I am going to sand it off and apply Minwax elsewhere. Rust-Oleum needs to stick with paint products.

Wish I could give this zero stars. This is NOT satin. No matter how much you stir during application, this ends up high-gloss. I'll now be sanding and adding a top coat of Minwax satin. Home Depot should not have stopped carrying Minwax.

This is the first time I used this brand (since Home Depot stopped selling Minwax) ... the Polyurethane finish had an inconsistent gloss and 'orange peel' texture. Each coat I added seemed to flatten out the rough orange peel finish in some areas, but then it appeared in new areas. I contacted the seller through their website, added photo and the requested information for help and received no response. I am going to strip off the polyurethane and try a different brand to fix my project. I am also returning the other Varathane products I bought for other furniture to HD ... very frustrating to put so much work into a piece only to have to do it over because of product problems with the final finish. I am also disappointed in Home depot ... my experience with their Behr paint got me to switch all my paint purchases to Home Depot ... there Varathane products are not up to the Behr standards.

Why HD decided to stop selling Minwax Oil-Based Poly, I have no idea. As previous reviewer mentioned, this poly does not produce a satin finish. I stirred as per instructions, but still got a glossy look (picture shows Varathane and Minwax clear satin finishes on similar stained Douglas Fir board). The application is also not as easy as the Minwax equivalent. I'm going back to get me some Minwax instead.

I purchased this product since my local Home Depot no longer carries Minwax poly. The finish looks good, but is much glossier than the Minwax equivalent. I would not recommend this product if you want a true satin finish.

Oil-based polyurethane is the best way to go. It gives a much tougher finish than water-based, and the smell is really not that bad and goes away quickly. To satisfy government VOC regulations, the can says you cannot spray it, but here is a secret - it sprays just fine! Of course, make sure you have adequate ventilation, and wear protection. Cleans up with mineral spirits. Can be tinted as well. I use it on guitar projects, where it polishes up to a mirror finish - the 'wet' look, with a slight yellowing that I like ( water-based does not yellow. )

This did not match an adjacent floor I finished last year with an older version of the product. On the plus side, it dries a little quicker and the fumes aren't as bad.

When you use the right brush and prepare surfaces properly the product is very easy to use. It goes on easy, dries relatively quickly and looks darn good when finished.

Good product, fairly easy to use.

The polyurethane satin worked perfectly for the teak table I stripped. It really brought out the wood grain beautifully.

Instructions on can should make clear that the product should be cut with mineral spirits to make application easier. Gets gummed up pretty quickly right out of the can

worked great for intended task.

The product said Satin Finish it was more like semi-gloss or gloss. Very shiny . Didn't match the satin finish on the rest of the cabinet we were repairing! Never saw Satin finish like this! Very disappointed. No time to sand down and start over. :(