Questions and Answers for Custom Building Products Aqua Mix 1 Qt. Nano Scrub Cleaner

A:  Residue from the Aqua Mix Nano Scrub Cleaner is removed with water, a nylon scrub brush and wet/dry shop vacuum. In order to give you the best possible answer we would like to know a few more details about your installation. Please contact our technical services department at 800 272-8786 option 3.

A:  Due to the nature of brick being extremely porous, the Aqua Mix Nano Scrub Cleaner would not be recommended unless the brick was properly sealed prior to application. A high alkaline or mild acidic cleaner may be a more suitable product depending on the type of contaminants being removed. For further assistance please contact our Care and Maintenance division at 800.272.8786 option 3

A:  Aqua Mix NanoScrub Cleaner is suitable to be used on VCT. We recommend using the cleaner with a white nylon scrub pad, then mopping and rinsing with clean water after. For further assistance please contact our Care and Maintenance division at 800.272.8786 option 3

A:  We would need more information about the type of grout you are asking about in order to give you the best information. Please contact our Technical Service Department at 800 272-8786 option 3 for further information.

A:  I used it to remove wax buildup on my porcelain tile.

A:  Aqua Mix Nano Scrub Cleaner can be used to remove factory applied waxes and floor finishes. For further assistance please contact our Care and Maintenance division at 800.272.8786 option 3

A:  Aqua Mix Nano Scrub Cleaner may be used to remove mild water deposits from stone tile. For further assistance please contact our Care and Maintenance division at 800.272.8786 option 3

A:  The cleaner can be used to remove light epoxy residue.

A:  Aqua Mix Nano Scrub may be used to remove light epoxy residue. Depending on the amount of residue, the Aqua Mix Sealer and Coating Remover may be recommended for best results. For further assistance please contact our Care and Maintenance division at 800.272.8786 option 3

A:  Probably not. Try using Bar Keepers Friend for dirt and stains.

A:  This will dissolve ground in dirt.

A:  This is meant to use as a abrasive. You must agitate it with a brush or pad. Also use Aqua Mix Heavy duty Tile and Grout Cleaner. Let it dwell for five minutes then apply Nano and agitate. Wipe clean and your done!

A:  We would recommend to use the TileLab Heavy-Duty Stripper and Cleaner and a white nylon scrub pad to remove access filler from the Travertine Repair Kit. For further assistance please contact our Care and Maintenance division at 800.272.8786 option 3

A:  Seems like it ..actually had grout on the tile for a few years that cleaned up pretty good.

A:  The coverage on the cleaner will depend on the surface you are using it on and what you are trying to remove. For further information please contact our technical service department at 800 272-8786 option 3.

A:  1 bottle may be enough, a little goes a long way, but it depends on how "dirty" the area is. I have about 1/3 bottle left and the area I used it on is about 160 Sq ft.