A: Hi Eddie - Thanks for reaching out! You will need a 3/8" drill bit.
by|Oct 11, 2023
3 found this answer helpful
Q:What length should I use to hold 2x4 baseplate in basement?
by|Jan 26, 2023
1 Answer
Answer This Question
A: Hi Scott - Thank you for reaching out! For application specific questions, please reach out directly to our customer service team at 877-489-2726.
by|Apr 2, 2024
1 found this answer helpful
Q:How much weight can it hold
by|Jul 30, 2022
1 Answer
Answer This Question
A: I used it to hang about 130LB with no problem.
by|Jul 30, 2022
Q:what is the thread size 3/8-??
by|Jul 16, 2022
1 Answer
Answer This Question
A: Hello! Thanks for your question. The threads per inch is 16 for the Red Head 3/8 in. x 3 in. Hex-Head Sleeve Anchors.
by|Jan 30, 2023
Q:I need to hang a 300 lb picture by 2 wires hanging from attachment points on a wall consisting of a skim coat of plaster over old (soft) bricks. Its a party wall so there are at least two courses. What diameter and depth do I need?
by|Jul 12, 2022
1 Answer
Answer This Question
A: Thank you for reaching out! For application specific questions, please reach out directly to our customer service team at 877-489-2726.
by|Jan 30, 2023
Q:Which would I use to anchor toilet to tile floor that's broken on one side of toilet to hold it tight?
by|Jan 16, 2022
2 Answers
Answer This Question
A: This is assuming you can't attach to the toilet to the flange? If you can't attach to the flange It depends on if the the subfloor is wood or a type of concrete. If it's concrete go with this. if it's wood, go with a large screw, again, that is if you can't attach to flange.
by|Jun 19, 2023
A: They sell a flange for that particular problem.
DANCO HydroSeat Toilet Flange Repair
by|Sep 24, 2022
Q:Are these actually useable for exterior applications? There are a lot of comments indicating that they are being used as such, but the Interior/Exterior specification in the product description shows "Interior"
by|Nov 10, 2021
1 Answer
Answer This Question
A: They are neither stainless nor (hot-dipped) galvanized, and will rust in months if exposed to atmospheric humidity or if they are embedded into concrete that contacts ground.
by|Sep 30, 2023
8 found this answer helpful
Q:How do I calculate the length I need if mounting 2x6 to the exterior of a block wall that has been parged with mortar. Does it matter if I hit a void or a web in the block? I can drill a test hole to measure how thick the parging is.
by|Oct 24, 2021
0 Answer
Answer This Question
Q:What if there's a layer of drywall or sheet rock in front of the brick. Will these work? Will it be too much pressure on the drywall?
by|Jul 14, 2021
0 Answer
Answer This Question
Q:What is the allowable load? Shear? Tension? Thanks, Vonn