Questions and Answers for Everbilt 22 in. Soft-Close Full Extension Side Mount Ball Bearing Drawer Slide Set 1-Pair (2 Pieces)

A:  50 pounds

A:  22” soft close will work. 

A:  If you are asking about 22” slider you might need drill hole in slider for 20” drawer.  

A:  Mine are 1 13/16"

A:  tall dimension is 1 13/16" (46mm) you can also check the specs sheet on the Home Depot product site.

A:  No. Go with the 20 in. slides. These fully extend so you should still be able to reach almost the back of the cabinet. If you go with a slide length (22 in.) that is longer than your cabinet depth (21 in.), the shelves will NOT close fully.

A:  You could use either IF the cabinet space is at least 20" deep. The 20" slides will allow the drawer to be pulled out 2" further Good luck

A:  Yes! Yes, you can!  The distance the drawer extends is based on the length of the slide and mounted position of the slide. If you only want the drawer to extend 10” then use a 10” slide! ;-) What you don’t want is a slide that is longer than the drawer! That causes a couple issues that can be a slap-the-forehead moment!

A:  you can but you won’t be able to pull out the full length of the drawer completely 

A:  You might have to modify the opening; install a shim under the drawer slide. 

A:  I don't know as I used them on Schrock cabinets, and they were too short, front-to-back, so I had to make a wooden block to attach to the rear of the cabinets in order to secure the slides to the back of the cabinets. I would not use these again.

A:  pepe, Thank you for your question. We cannot recommend our hinge for toolboxes, they have not been tested on them. Best, Customer Care Team

A:  Erik, Thank you for your question on the Everbilt 22 in. Soft-Close Full Extension Side Mount Ball Bearing Drawer Slide Set 1-Pair. The side mounted slides don't come in that length. Undermount slides do come in 21 inch length.--Best, Customer Care