Questions and Answers for Fiskars PowerLever 1-1/8 in. Cut Capacity Steel Saw Blade 15 in. Fiberglass Pole 14 ft. Tree Pruner

A:  Thank you for contacting Fiskars. When not extended, this tree pruner is 7 feet long, so you can extend it to 9 feet.

A:  Thank you for contacting Fiskars. The cut capacity for this tree pruner is 1-1/8 inches. The saw blade should have no problem cutting palm fronds. If the palm fronds are within the cutting capacity of the cutting blade, you should have no problem with that as well.

A:  Thank you for contacting Fiskars. The blade provided is the only blade compatible with this tree pruner.

A:  Thank you for contacting Fiskars. You can contact the warranty department here: warranty@fiskars.com (include your name, shipping address, photo of the entire item, and the issue).

A:  Thank you for contacting Fiskars. Yes, this item extends up to 14 feet.

A:  Thank you for contacting Fiskars. Please contact the warranty department regarding this: warranty@fiskars.com (include your name, shipping address, photo of the entire item, and the issue).

A:  Thank you for contacting Fiskars. The blade doesn't need to be oiled, but you can apply some to keep it from rusting. You can use any kind of oil.

A:  You can try the following methods (if none of these work, please contact our warranty department: warranty@fiskars.com). 1. Soak the threads in the center of the wing nut with spray-penetrating lubricant. Allow the lubricant to work for ten minutes. 2. Place the tip of a flat-head screwdriver against the right side of one wing. Tap the end of the screwdriver to get the wing nut to start rotating counterclockwise. Once the wing nut begins to turn, twist it counterclockwise by hand until it is off the threaded shaft. 3. Lay the shaft of the screwdriver between the threaded shaft and the right side of the wing nut. Pull the screwdriver handle counterclockwise using the threaded stem as leverage. This is usually enough to begin turning the wing nut.