#1 Home Improvement Retailer

Questions and Answers for OOK 100 lbs. Bear Claw 4-in-1 Screw Hooks (12-Pack)

Internet #202258021

Model #55300

Store SKU #180537

  • Metallic finish blends with open-back frames and canvas art
  • Bear claw screw hooks enable level hanging
  • Install to support frames that weigh up to 100 lbs.

Questions & Answers

24Questions
caret
Q:How much weight could these support if you were using them to hand something from the ceiling into the drywall?
by|May 14, 2021
2 Answers
Answer This Question

A:  Is this your first job ? it is just a screw / put it in a stud or use a toggle bolt for the ceiling .

by|Mar 8, 2023
    1 found this answer helpful

    A:  Hi, and thank you for your question. This product has not been tested on ceiling holding power. And its not intended for that type of weight load angle.

    by|May 18, 2021
      caret
      Q:Will this go in plaster wall? Ook.100lbs bear claw 4 in 1 screw hooks
      by|Apr 20, 2021
      2 Answers
      Answer This Question

      A:  Yes I use them on my plaster walls (house is from circa 1925) and they work great

      by|Jun 7, 2023
      1 found this answer helpful

      A:  Hi Jackie, and thank you for your question. These could be used in plaster, but a small pilot hole should be pre-drilled whenever screwing into plaster. You may want to use a small piece of painters tape or masking tape in the area where the hole will be drilled to help prevent chipping of the plaster. The Ook Professional Hangers are an excellent alternative for plaster also.

      by|May 11, 2021
        caret
        Q:What is the diameter of the head?
        by|Mar 26, 2021
        1 Answer
        Answer This Question

        A:  Hi, and thank you for your question. The head of the 4 in 1 screw is 3/8".

        by|Apr 5, 2021
          caret
          Q:Can these be used on Hardie board panels?
          by|Feb 23, 2021
          2 Answers
          Answer This Question

          A:  Hi Lee, and thank you for your question. As long as you use a pilot hole, these should work on Hardie board panels

          by|Apr 6, 2021

            A:  i would not use / you need a double thread /

            by|Jan 30, 2024
              caret
              Q:Diameter length and width!
              by|Dec 18, 2020
              2 Answers
              Answer This Question

              A:  Hi Robert, and thank you for your question. This hook is 1/4" thread, 0.250" diameter and 1.5" in length.

              by|Dec 29, 2020

                A:  Works great to hang big art pieces.

                by|Sep 8, 2022
                caret
                Q:I know is weird question, but can i use it to screw into air duct? does it gonna hold speaker?
                by|Nov 23, 2020
                4 Answers
                Answer This Question

                A:  Yes, you can. I did screw it into metal stud. You need to drill a pilot hole though. I used a #6 self- drilling screw. I cannot guarantee it will hold your speaker. I hung pictures, pretty lightweight. Basically this thread is not designed to hold in thin metal. I wouldn't bank on it but it also depends on your speaker weight.

                by|Nov 23, 2020

                A:  You should use a sheet metal screw .

                by|Nov 24, 2021

                  A:  You might want to drill a small hole in the duct for screw to start into the duct. Not sure how much weight this could support, likely much, much less than a hundred pounds.

                  by|Nov 30, 2020

                  A:  Hi, and thank you for your question. This product is not for use in metal

                  by|May 24, 2023
                    caret
                    Q:If one screw can hold 30 lbs. in drywall,does that mean four screws can hold 120 lbs. in drywall ?
                    by|Aug 20, 2020
                    3 Answers
                    Answer This Question

                    A:  Theoretically yes. If load is distributed evenly. In real life most probably one or two screws will bear most of the load.

                    by|Dec 1, 2022
                    2 found this answer helpful

                    A:  Thank you for your interest in Hillman products. No, adding additional screws does not guarantee an equivalent increase in safe working load.

                    by|Dec 1, 2022
                      2 found this answer helpful

                      A:  If the four screws are positioned in such a way that each supports 30 of 120 lbs. the four 100 lb capacity screws should work fine.

                      by|Aug 20, 2020
                      1 found this answer helpful
                      caret
                      Q:Can this be used outside?
                      by|Jun 20, 2020
                      3 Answers
                      Answer This Question

                      A:  Thank you for your interest in Hillman products. We do not recommend using this product outside as it will corrode over time.

                      by|Jun 23, 2020

                        A:  I have not used them outside, but they look like a reasonable choice for outdoors. I would give it a try and check once in awhile to see how they hold up. They are my favorite anchor indoors for pictures.

                        by|Jun 23, 2020

                        A:  I use these on my fences to hold tools, hose hangers, etc. They are coated with better protection than the average screw. Yes, I would use them outside as I have for over 16 years.

                        by|Jun 24, 2020
                        caret
                        Q:Dresser anchor
                        by|Jun 15, 2020
                        1 Answer
                        Answer This Question

                        A:  Thank you for your interest in Hillman products.This item has a weight rating of 100lbs., capacity or anchoring this dresser however will depend on installation method which we are not certain of thus can not specify if it will hold or not.

                        by|Jun 18, 2020
                          caret
                          Q:What size anchor to go along with this screw? Don't want to rely only on drywall, would like to use an anchor with it.
                          by|Apr 24, 2020
                          2 Answers
                          Answer This Question

                          A:  Hi and thank you for your inquiry. This item was not designed to be used with an anchor. In order to get the 100 Lbs rating, this item will need to be placed in a stud.

                          by|Jan 10, 2021

                            A:  Alligator AF6 will work

                            by|Oct 12, 2023
                            2 found this answer helpful

                            Frequently Bought Together

                            Top Rated
                            +
                            +
                            Price:
                            $793

                            Compare Similar Decorative Screws

                            current product
                            Top Rated100 lbs. Bear Claw 4-in-1 Screw Hooks (12-Pack)
                            Top Rated4 in 1 Screw with level1 in. Bear Claw Double-Headed Anchorless Screw (25-Pack)
                            BrandOOKOOKSIMPLE MOUNT
                            Name100 lbs. Bear Claw 4-in-1 Screw Hooks (12-Pack)4 in 1 Screw with level1 in. Bear Claw Double-Headed Anchorless Screw (25-Pack)
                            Price
                            $793
                            $469
                            $906
                            Ratings
                            (273)
                            (273)
                            (39)
                            Screw Length1-1/2 in1-1/2 in1 in
                            Head StyleWafer HeadWafer HeadFlat Head
                            Size1/2 in1/4 in#8
                            Interior/ExteriorInteriorInteriorInterior
                            View ProductView ProductView Product