#1 Home Improvement Retailer

Customer Reviews for Tapcon 5/32 in. Steel SDS Carbide Masonry Drill Bit (1-Piece)

Internet #202097023

Model #11492

Store SKU #163610

  • Compatible for use with 3/16 in. Tapcon concrete anchors
  • For use with SDS plus chuck hammer drills
  • Carbide tip delivers strength for drilling into tough materials

Customer Reviews

  • 4
    out of 609 reviews
  • 65% recommend this product
Filter by:
Showing 1-30 of 609 reviews
by
  • Verified Purchase
Good product
More robust than other bits purchased for concrete screws.
by
  • Verified Purchase
  • Recommended
by
  • Verified Purchase
by
  • Verified Purchase
Broke very quickly. There is a different brand that...
Broke very quickly. There is a different brand that I usually buy that is much stronger.
by
  • Verified Purchase
Totally dissatisfied, I plan to return it...
Totally dissatisfied, I plan to return it
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
Bent as soon as I pulled the trigger!...
Bent as soon as I pulled the trigger!
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
Cuts like butter
Had to drill some holes for Tapcons in a concrete block wall. This bit went through it like butter (with a Milwaukee impact driver). I haven't had a lot of use yet, so I can't say how well it will stand up over time, but so far, it works well.
by
  • Verified Purchase
  • Recommended
by
  • Verified Purchase
Broke on first hole
The bottom 1/4" of the bit sheared off within the first 1/2 of the first hole. $11 bucks down the drain.
by
    by
    • Verified Purchase
    Dulled out after drilling three 2.5 inch holes in concrete,...
    Dulled out after drilling three 2.5 inch holes in concrete, after that this bit would barely cut into the concrete.
    by
    • Verified Purchase
    The SDS bits and rotary hammer drill are the way...
    The SDS bits and rotary hammer drill are the way to go when drilling into concrete but, a couple or warnings. Do not use the rotary hammer setting on brick pavers, it will shatter them. Make sure you are using the correct size bit for the Tapcon screws you are using as it can be confusing. 1/4" Tapcon screw requires this 3/16" bit.
    by
    • Verified Purchase
    Rating provided by a verified purchaser...
    Rating provided by a verified purchaser
    by
    • Verified Purchase
    The drill broke after 3 holes drilled. The cheaper one...
    The drill broke after 3 holes drilled. The cheaper one same size worked like a champ.
    by
    • Verified Purchase
    Rating provided by a verified purchaser...
    Rating provided by a verified purchaser
    by
    • Verified Purchase
    by
    • Verified Purchase
    This bit is just the right size for the tapcon...
    This bit is just the right size for the tapcon it is intended for!
    by
    • Verified Purchase
    Showing 1-30 of 609 reviews

    Frequently Bought Together

    Top Rated
    +
    +
    Price:
    $1097